CONSTRUCTION
The FC stack assembly is a device that uses a chemical reaction between hydrogen and oxygen to generate electrical energy.
The FC stack assembly is composed of parts such as 330 fuel battery cells, an FC stack voltage sensor, air system parts (such as the FC air by-pass valve assembly, air pressure regulating valve (FC air pressure regulator assembly) and air sealing valve (FC air pressure regulator assembly)), cooling system parts, and high voltage parts.
| *1 | FC Stack Assembly | *2 | FC Stack Ventilation Cover |
| *3 | FC Stack Case Plug Cover | *4 | No. 2 FC Stack Case Plug |
| *5 | FC Stack Voltage Sensor | *6 | FC Stack Manifold Assembly |
| *7 | Air Pressure Regulating Valve (FC Air Pressure Regulator Assembly) | *8 | FC Air By-pass Valve Assembly |
| *9 | Air Sealing Valve (FC Air Pressure Regulator Assembly) | *10 | Water Temperature Sensor (for FC Stack Outlet Side) |
FC stack
The FC stack is composed of 330 fuel cells connected in series.
| *1 | FC Stack | - | - |
FC Stack Voltage Sensor
The FC stack voltage sensor detects the FC stack condition (voltage) and sends this information to the EV control ECU through the FC DC converter control ECU board sub-assembly as the average voltage and self-diagnosis information.
FC Stack Ventilation Cover
The FC stack ventilation cover suppresses the mixing of foreign matter such as mud and dust in the stack case and protects the FC stack, and also performs ventilation so that the average concentration of hydrogen inside the stack case will be less than 4%.
The FC stack ventilation cover is composed of a housing made of plastic resin and a ventilation membrane.
FC Stack Case Plug
The No. 2 FC stack case plug suppresses the mixing of foreign matter such as mud and dust in the stack case. Additionally, when the pressure in the FC stack increases due to abnormal hydrogen combustion of the FC stack assembly, it is structured to release pressure inside the FC stack by breaking.
FC Stack Case Plug Cover
The FC stack case plug cover protects the No. 2 FC stack case plug from flying stones, direct contact, etc.
Stack Manifold
The FC stack manifold assembly forms passages for hydrogen, air and coolant, provides an isolating function for passages touching high voltage parts (power generation area) and high voltage coolant inside the stack as well as a load bearing function to compress the fuel battery cell layered body, while its integrated frame of resin and aluminum improves dimensional precision and achieves compactness.