CONSTRUCTION
Aero Stabilizing Fin
An aero stabilizing fin is provided in the front door front lower frame cover upper. The air flowing over the aero stabilizing fin generates spiral turbulence behind the fin. This turbulence suppresses air separation from the side of the body, reduces air resistance (the resistance due to the negative pressure that occurs behind physical objects) and laterally presses against the vehicle to ensure superior driving stability.
The front door outside handle assembly and rear door outside handle assembly are given shapes with the same feature as the aero stabilizing fin.
| *1 | Front Door Front Lower Frame Cover Upper LH | *2 | Front Door Outside Handle Assembly LH |
| *3 | Rear Door Outside Handle Assembly LH | - | - |
| *a | Aero Stabilizing Fin | *b | Turbulence |
Aluminum Tape
Aluminum tape (molding tape No. 1) is provided on the back of the rear bumper cover. The body and air become positively charged when driving, making it easier for the air to separate from the body. Aluminum tape that effectively discharges the electrical charge of the vehicle is optimally positioned because air separation generates turbulence and prevents aerodynamic effects. As a result, nearby air separation is suppressed, ensuring superior operational stability.
| *1 | Molding Tape No. 1 | *2 | Rear Bumper Cover |
Under Cover
The body rocker panel molding assemblies (*9 and *10 in illustration) are positioned so that they overlap the under cover (*c in illustration). This expands the under cover floor cover range and reduces air resistance of flattened floor components and the under cover, improving fuel efficiency.
Aero stabilizing fins are optimally positioned on the underside of the vehicle to adjust the air flowing under the vehicle and effectively generate downforce.
| *1 | Front Compartment Under Cover | *2 | Fender Splash Shield Sub-assembly Front LH |
| *3 | Fender Splash Shield Sub-Assembly Front RH | *4 | Front Suspension Member Protector LWR |
| *5 | Front Compartment Under Cover Assembly | *6 | Rear Floor Board Sub-assembly No. 4 |
| *7 | Floor Board Sub-assembly No. 2 | *8 | Floor Board Sub-assembly No. 1 |
| *9 | Rocker Panel Molding LH | *10 | Rocker Panel Molding RH |
| *11 | Rear Floor Board Sub-assembly No. 3 | *12 | Rear Floor Side Member Cover LH |
| *13 | Rear Floor Side Member Cover RH | *14 | Differential Support Protector No. 2 |
| *15 | Differential Support Protector No. 1 | *16 | Rear Suspension Brace Cover |
| *17 | Transmission Oil Cooler Under Cover LH | *18 | Transmission Oil Cooler Under Cover RH |
| *19 | Floor Under Cover No. 1 | - | - |
| *a | A - A Cross Section | *b | Enlarged Illustration of B |
| *c | Overlap Area | *d | Aero Stabilizing Fin |
Luggage Compartment Panel Shape
The rear end portion of the luggage compartment door panel sub-assembly has been given a spoiler shape, aiming for air resistance reduction by smoothly introducing airflow from the roof to the rear.
| *1 | Luggage Compartment Door Panel Sub-assembly | - | - |
|
Airflow | - | - |
Wheel House Liner
Beads are provided to free the high-pressure turbulence outward that causes air resistance in the wheelhouse by the rotation of the tires.
| *1 | Fender Splash Shield Sub-assembly Front LH | *2 | Rear Wheel House Liner |
| *a | Airflow Caused by Tire Rotation | *b | Bead |
| *c | Air Introduction by Bead | - | - |