FUNCTION
The air required by the FC stack assembly for electrical generation passes through the air cleaner and is then compressed by the FC air compressor with motor assembly to a maximum pressure of 250 kPa (abs), and is supplied to the FC stack assembly.
The intake air compressed by the FC air compressor with motor assembly is cooled by the large water cooled intercooler.
The air shunt valve (FC air pressure regulator assembly) on the air supply side of the FC stack and the air pressure regulating valve (FC air pressure regulator assembly) on the exhaust side shunt the cathode side when the system is stopped and adjust pressure when the system is operating.
The FC air bypass valve adjusts the amount of air entering the FC stack assembly distributed to the exhaust .
FC Air Compressor Control
The EV control ECU calculates the appropriate air volume based on received signals, and sends FC air compressor operation request signals to the MG ECU.
The MG ECU drives the FC air compressor with motor assembly based on the request from the EV control ECU.
Air Shunt Valve (FC Air Pressure Regulator Assembly) System
The FC control ECU uses the air shunt valve (FC air pressure regulator assembly) at the inlet of the FC stack assembly to adjust the amount of air flowing into the FC stack assembly, and opens and closes the valve according to the vehicle driving conditions.
Air Pressure Regulating Valve (FC Air Pressure Regulator assembly) System
The FC control ECU uses the air pressure regulating valve (FC air pressure regulator assembly) at the outlet of the FC stack assembly to adjust the pressure in the FC stack assembly according to the vehicle driving conditions.
FC Air Bypass Valve System
The FC control ECU uses the FC air bypass valve upstream from the FC stack assembly to finely adjust the amount of air flowing into the FC stack assembly.