Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM › from 2021.08
NM37H0E _58 Vehicle Interior _097454 SUPPLEMENTAL RESTRAINT SYSTEMS _0498698 OCCUPANT CLASSIFICATION SYSTEM CO CONTROL F

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  CONTROL  OCCUPANT CLASSIFICATION CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components in the occupant classification system have the following functions:

Component Function
Occupant Detection ECU Judges whether the front passenger seat is occupied based on signals from 2 occupant classification sensors and the front passenger seat belt buckle switch.
Airbag ECU Assembly
·

Receives the signals of the result of the judgment from the occupant detection ECU, and restricts the deployment of the SRS front passenger airbag and SRS front passenger knee airbag.

·

Outputs the illumination signals to the AIRBAG ON/OFF indicator lights.


Front Occupant Classification Sensor The output values of this sensor, which vary in accordance with the distortion that acts on the brackets, are output to the occupant detection ECU.
Rear Occupant Classification Sensor
Front Passenger Seat Belt Buckle Switch (Front Seat Inner Belt Assembly RH) Detects if the front passenger seat belt is fastened.
Telltale Light Assembly AIRBAG ON
Indicator Light
Turns on to inform the driver when the occupant detection ECU has put the SRS front passenger airbag and SRS front passenger knee airbag into an active state.
AIRBAG OFF
Indicator Light
·

Turns on to inform the driver when the occupant detection ECU has put the SRS front passenger airbag and SRS front passenger knee airbag into an inactive state.

·

Turns on to alert the driver when the airbag ECU assembly detects a malfunction in the occupant classification system.


Combination Meter Assembly SRS Warning Indicator Turns on to alert the driver when the airbag ECU assembly detects a malfunction in the SRS airbag system.
DLC3 The Global TechStream (GTS) can be connected to read the Diagnostic Trouble Codes (DTCs) of malfunctions.



OPERATING CONDITION


a.

The front passenger SRS items and indicator lights operate as follows according to the occupant classification:

Item Occupant Classification
Adult*1 Child*2 Child Seat Unoccupied Malfunction

○ : Enabled

X : Disabled

Front Passenger Airbag ○ X X X X
Front Passenger Knee Airbag ○ X X X X
Front Passenger Side Airbag ○ ○ ○ ○ ○
Curtain Shield Airbag Assembly RH ○ ○ ○ ○ ○
Front Passenger Seat Belt Pretensioner ○ ○ ○ ○ ○
ON Indicator Light Illuminates - - - -
OFF Indicator Light - Illuminates Illuminates Illuminates Illuminates

HINT:

*1: The system judges a person of average adult weight or more as an adult. If a smaller adult sits in the front passenger seat, the system may not recognize them as an adult depending on their physique and posture.

*2: The system may not recognize a child or a child in a child restraint system as a child depending on factors such as the positioning of the child restraint system or the child's physique or posture.




SYSTEM CONTROL


a.

Summary

i.

In the occupant classification system, the occupant detection ECU calculates the weight of the occupant based on signals from the occupant classification sensors.


ii.

The occupant detection ECU contains criteria value "A" to judge whether the seat is occupied by a child or is unoccupied in accordance with the signals from the 2 occupant classification sensors and front passenger seat belt buckle switch, and criteria value "B" to judge whether the occupant is an adult or child (with child seat).


iii.

This system recognizes the occupant as a child or child seat if it detects a weight of less than criteria value "B", and disables the SRS front passenger airbag and SRS front passenger knee airbag.



b.

Unoccupied Judgment

i.

The occupant detection ECU makes an unoccupied judgment when the judgment value is lower than criteria value "A" and the front passenger seat belt buckle switch is off.


ii.

If the ignition switch is turned on (IG) in this state, the system performs an initial check, and illuminates the AIRBAG OFF indicator light. Then, the system prohibits the deployment of the SRS front passenger airbag and SRS front passenger knee airbag, and does not blink the seat belt warning indicator.

Y274927E01
2.813,1.063 4.458,1.417 1.646,0.354 10 false Occupant Detection ECU 2.813,1.365 5.115,1.646 2.302,0.281 10 false Unoccupied: Judgment Value < "A" 5.708,2.448 6.427,2.802 0.719,0.354 10 false Off Signal 0.323,2.844 2.906,3.573 2.583,0.729 10 false Front Passenger Airbag (Instrument Panel Passenger Airbag without Door Assembly) 0.292,3.885 2.927,4.573 2.635,0.688 10 false Front Passenger Knee Airbag (Lower No. 2 Instrument Panel Airbag Assembly) 0.396,4.927 2.906,5.563 2.51,0.635 10 false Front Passenger Side Airbag (Front Seat Airbag Assembly LH) 0.531,5.927 2.813,6.208 2.281,0.281 10 false Front Seat Outer Belt Assembly RH 5.333,6.208 7.073,6.573 1.74,0.365 10 false Seat Belt Warning Indicator 5,4.844 6.875,5.104 1.875,0.26 10 false AIRBAG OFF Indicator Light 5,3.698 6.708,3.948 1.708,0.25 10 false AIRBAG ON Indicator Light 0.531,6.26 2.813,6.542 2.281,0.281 10 false - Seat Belt Pretensioner 3.604,4.083 4.375,4.823 0.771,0.74 10 false Airbag ECU Assembly



c.

Child Seat or Child Judgment

i.

If the judgment value is lower than criteria value "B" and the front passenger seat belt buckle switch is on, the occupant detection ECU judges that a child seat is installed.


ii.

If the judgment value is higher than criteria value "A", but lower than criteria value "B", and the front passenger seat belt buckle switch is off, the occupant detection ECU judges that the seat is being occupied by a child.


iii.

When the ignition switch is turned on (IG) under these conditions, the system performs an initial check and illuminates the AIRBAG OFF indicator light to indicate that the SRS front passenger airbag and SRS front passenger knee airbag have been deactivated.

Y274928E01
2.76,0.75 4.365,1.042 1.604,0.292 10 false Occupant Detection ECU 0.323,2.948 2.938,3.625 2.615,0.677 10 false Front Passenger Airbag (Instrument Panel Passenger Airbag without Door Assembly) 0.323,3.948 2.948,4.563 2.625,0.615 10 false Front Passenger Knee Airbag (Lower No. 2 Instrument Panel Airbag Assembly) 0.406,4.99 2.938,5.615 2.531,0.625 10 false Front Passenger Side Airbag (Front Seat Airbag Assembly LH) 0.521,6 2.813,6.302 2.292,0.302 10 false Front Seat Outer Belt Assembly RH 3.604,4.125 4.375,4.865 0.771,0.74 10 false Airbag ECU Assembly 5.01,3.688 6.813,3.958 1.802,0.271 10 false AIRBAG ON Indicator Light 4.979,4.844 6.844,5.094 1.865,0.25 10 false AIRBAG OFF Indicator Light 5.698,2.458 6.365,2.781 0.667,0.323 10 false On Signal 2.302,1.792 3.01,2.052 0.708,0.26 10 false Off Signal 2.771,1.052 4.927,1.354 2.156,0.302 10 false Child Seat: Judgment Value < "B" 2.771,1.365 4.979,1.677 2.208,0.313 10 false Child: "A" < Judgment Value < "B" 0.531,6.375 2.823,6.677 2.292,0.302 10 false - Seat Belt Pretensioner



d.

Adult Judgment

i.

After the occupant detection ECU judges that a child seat is installed, the AIRBAG OFF indicator light does not go off unless the front passenger seat belt buckle switch is turned off.


ii.

When the judgment value is higher than criteria value "B", the occupant detection ECU judges that the seat is occupied by an adult.


iii.

If the ignition switch is turned on (IG) in this state, the system performs an initial check and illuminates the AIRBAG ON indicator light, indicating that the SRS front passenger airbag and SRS front passenger knee airbag are active.

Y275120E02
3.031,1.063 4.656,1.396 1.625,0.333 10 false Occupant Detection ECU 3.031,1.396 4.792,1.698 1.76,0.302 10 false Adult: "B" < Judgment Value 5.646,2.438 6.698,2.771 1.052,0.333 10 false On or Off Signal 0.333,2.844 2.927,3.5 2.594,0.656 10 false Front Passenger Airbag (Instrument Panel Passenger Airbag without Door Assembly) 0.313,3.948 2.979,4.625 2.667,0.677 10 false Front Passenger Knee Airbag (Lower No. 2 Instrument Panel Airbag Assembly) 0.385,4.948 2.927,5.594 2.542,0.646 10 false Front Passenger Side Airbag (Front Seat Airbag Assembly LH) 0.51,6.031 2.771,6.344 2.26,0.313 10 false Front Seat Outer Belt Assembly RH 3.583,4.094 4.344,4.865 0.76,0.771 10 false Airbag ECU Assembly 4.969,3.677 6.865,4.042 1.896,0.365 10 false AIRBAG ON Indicator Light 5,4.854 6.844,5.094 1.844,0.24 10 false AIRBAG OFF Indicator Light 0.51,6.365 2.771,6.677 2.26,0.313 10 false - Seat Belt Pretensioner



e.

After the ignition switch is turned to on (IG), the occupant detection ECU illuminates the AIRBAG ON/OFF indicator lights via the airbag ECU assembly based on the timing chart below in order to check the indicator light circuits:

Y204738E07
4.385,4.313 4.385,3.625 true 4.375,2.542 4.375,1.854 true 0.479,0.406 1.51,0.698 1.031,0.292 10 false Ignition Switch 1.719,0.229 2.583,0.594 0.865,0.365 10 false On (IG) 1.958,0.583 2.198,0.833 0.24,0.25 10 false Off 1.969,1.167 2.229,1.5 0.26,0.333 10 false On 0.354,1.313 1.677,2.021 1.323,0.708 10 false AIRBAG ON Indicator Light 0.365,3.125 1.792,3.938 1.427,0.813 10 false AIRBAG OFF Indicator Light 3.031,3.635 3.979,4.281 0.948,0.646 10 false Approximately 4 seconds 4.771,3.604 6.885,4.26 2.115,0.656 10 false On/Off condition depends on the front passenger detection result 3.979,2.563 4.927,2.927 0.948,0.365 10 false Approximately 2 seconds 1.979,1.51 2.219,1.76 0.24,0.25 10 false Off 1.979,3.281 2.219,3.531 0.24,0.25 10 false Off 1.979,2.917 2.24,3.25 0.26,0.333 10 false On 4.75,1.833 6.865,2.49 2.115,0.656 10 false On/Off condition depends on the front passenger detection result 3.01,1.865 3.958,2.51 0.948,0.646 10 false Approximately 4 seconds 4.052,4.323 5,4.688 0.948,0.365 10 false Approximately 2 seconds



DIAGNOSIS


a.

If the occupant detection ECU detects a malfunction in the occupant classification system, the occupant detection ECU stores the malfunction data in memory. If the airbag ECU assembly detects a malfunction in the occupant detection ECU, the airbag ECU assembly illuminates the SRS warning light and AIRBAG OFF indicator light.


b.

The occupant detection ECU outputs Diagnostic Trouble Codes (DTCs) to the Global TechStream (GTS).


c.

The DTCs can be read by connecting the Global TechStream (GTS) to the DLC3. For details, refer to the Repair Manual.