FUNCTION OF MAIN COMPONENTS
| Component | Function | ||
|---|---|---|---|
|
*: The green and red indicator lights turn on for 5 seconds immediately after the ignition switch is turned ACC. |
|||
| Navigation Antenna Assembly
·
Telephone Antenna (Main) ·
GPS Antenna |
·
Sends and receives the data and voice signals used for the TOYOTA Connect service through a communication network. ·
Receives GPS radio waves used for the vehicle location information. |
||
| Navigation Antenna Assembly
·
Telephone Antenna (Sub) |
Receives the data and voice signals used for the TOYOTA Connect service through a communication network. | ||
| Map Light Assembly | Houses the emergency call switch. | ||
| Telephone Microphone Assembly | Sends the microphone voice signal to the DCM. | ||
| Emergency Call Switch | When pressed, sends a switch signal to the DCM.
(When a manual maintenance check or manual emergency call is performed.) |
||
| LED Indicator Light* | Green | ·
Turns on when the system is under a service contract and operating normally within the service area. ·
Blinks during a call or a maintenance check and turns off when the system is malfunctioning. |
|
| Red | ·
Turns on when the vehicle is not within the service area. ·
Blinks when an emergency call or maintenance check has been aborted. ·
Turns off when the system is operating normally. ·
Blinks when in diagnostic mode to indicate a DTC. |
||
| DCM (Telematics Transceiver) | Uses the navigation antenna assembly to send and receive the data and voice signals used for the TOYOTA Connect system through a communication network
·
When an emergency call is made: Sends a received voice signal to the front No. 1 speaker assembly RH and front No. 3 speaker assembly RH. ·
When an emergency call is made: Receives a sent voice signal from the telephone microphone assembly. ·
When an emergency call is made: Sends a mute signal to the audio head unit. (Mute function becomes active during the call.) ·
When an emergency call is made: Sends location information to the TOYOTA Connect Center. ·
When a warning comes on: Receives a signal indicating the failure or malfunction of a system from the combination meter assembly via CAN communication and sends it to the TOYOTA Connect Center. ·
When the theft deterrent system is activated: Sends to the TOYOTA Connect Center information that the security horn has sounded. |
||
| Mobilephone Battery (Back-up Battery) | Is built into the DCM and supplies power to the DCM when the automatic emergency call service is activated and the vehicle battery cannot supply power. | ||
| Audio Head Unit (Radio Receiver Assembly) | ·
Sends and receives the data used for the TOYOTA Connect system to and from the DCM using a telematics data signal. ·
Receives the mute signal from the DCM to mute any audio sound. |
||
| Steering Pad Switch Assembly | Sends operation signals from voice switch to the audio head unit. | ||
| Main Body ECU (Multiplex Network Body ECU) | Sends a security control signal to the DCM when the theft deterrent system is activated. | ||
| Airbag ECU Assembly | Sends an activation signal to the DCM when the airbags deploy is detected. | ||
| Front No. 1 Speaker Assembly RH | When an emergency call is made: Outputs the TOYOTA Connect Center operator's voice sounds. | ||
| Front No. 3 Speaker Assembly RH | |||
| DLC3 | Allows system diagnosis to be performed when GTS. | ||
FUNCTION
Emergency Call Service
The emergency call service automatically makes a call to a TOYOTA Connect center operator in the event of an accident, such as one that makes airbags deploy, in order to support prompt attendance by emergency personnel.
In the event of trouble such as an accident or sudden illness, the DCM can be used to call the emergency call center and send location information and the registered user information
| *a | Emergency Call Service | *b | GPS Satellite |
| *c | Cellular Phone Line | *d | Cellular Phone Base Station |
| *e | TOYOTA Connect Center | *f | Emergency Call Center |
| *g | Public Fixed Line | *h | Emergency Vehicle |
| *i | Public safety authorities such as police or fire department | *j | The illustrations shown are examples only. The illustrations may differ from the actual service. |
The emergency call service can be activated manually to contact the TOYOTA Connect Center.
| Call Method | Operation Condition |
|---|---|
| Automatic Call | An automatic call is made in the event of an accident, such as one that makes the airbags deploy. The call occurs regardless of the condition of the occupants. |
| Manual Emergency Call | In the event of a sudden illness or an accident, a manual emergency call can be made by pressing the emergency call switch in the overhead console.
(To press the emergency call switch, the emergency call switch cover needs to be removed.) |
The emergency call service operation and contract conditions can be confirmed by accessing the TOYOTA Connect Center and performing the following maintenance checks.
| Maintenance Check | Outline |
|---|---|
| Automatic Maintenance Check | The DCM automatically and periodically accesses the emergency call center to confirm if the user is still registered |
| Manual Maintenance Check | The user can press the emergency call switch for 10 seconds or more while the green and red indicator lights are on immediately after the ignition switch is turned ON to access the TOYOTA Connect Center and confirm that they are still registered. |
In the following cases, the emergency call service may not be available or the service quality may suffer.
The TOYOTA Connect online service has not been established or the first manual maintenance check has not been completed.
Communication is interrupted due to a malfunction of the DCM or any other related device.
The location cannot be determined.
Communication is interrupted due to a service provider system malfunction.
Communication problems occur in the communication network used for the emergency call service.
The emergency call service is suspended or halted due to emergency call provider reasons.
Although a manual emergency call is made, the situation cannot be confirmed because the user cannot respond to questions from the TOYOTA Connect Center.
Theft Tracking Service (Automatic Alarm Notification, Vehicle Tracking and Authorities Contact)
The theft tracking service notifies the TOYOTA Connect Center that the alarm has operated when the theft deterrent system is activated.
The TOYOTA Connect Center makes a call to the user to notify them that the alarm has operated.
In the event of theft, the vehicle location can be tracked as requested by the user. If requested by the user, a TOYOTA Connect operator asks the authorities to find the stolen vehicle and take the case under their control.
| *a | Customer's Vehicle | *b | Automatic Alarm Operates |
| *c | TOYOTA Connect Center | *d | Authorities |
| *e | Customer's cellular phone registered in the TOYOTA Connect Center | - | - |
| No. | Process of Alarm Notification |
|---|---|
| (1) | Trouble occurs and the automatic alarm operates. |
| (2) | The vehicle location is confirmed. |
| (3) | The user is notified about the trouble by a call. If the call cannot get through, the user is notified by a Short Message Service (SMS) message. |
| (4) | The user makes a request. |
| (5) | A call-out is made to the authorities. |
| (6) | The authorities respond to the scene. |
DIAGNOSIS
When the DCM detects a malfunction in the telematics system, Diagnostic Trouble Codes (DTCs) are stored in memory.
The DTCs can be read using the GTS. For details, refer to the Repair Manual.