If work is performed without first securing the vehicle, the vehicle may start moving and cause a serious accident or other disaster. Therefore, be sure to apply the parking brake and use wheel chocks to secure the vehicle before performing work.
Perform the parking lock release operation with the vehicle level.
When the work is done on a incline, there is the danger that the vehicle will start to move, leading to a serious injury.
1. SECURE VEHICLE
Apply the parking brake.
Turn the ignition switch off and use wheel chocks to secure the vehicle.
During power failure, make sure use wheel chocks to secure the vehicle as the parking brake cannot be used.
2.PARKING LOCK FORCED RELEASE
The procedure is conducted from the side of the rear wheel, so do not turn the ignition switch to ON.
The depressing of the brake pedal in the driver seat and the release of the parking lock from the side of the rear wheel on the left side of the vehicle are conducted simultaneously, therefore this procedure must by performed by 2 people.
Sit in the vehicle alone.
Combine the tools as shown in the illustration.
Technician 1:
Depress and hold the brake pedal.
Keep the brake pedal depressed until the parking lock is released and technician 2 moves away from the vehicle.
Technician 2:
Insert the tool from the gap in the under cover, and fit the tool onto the outer lever end by looking through the hole for visual confirmation.
| *1 | Outer Lever | - | - |
| *a | Hole for visual confirmation | - | - |
|
Release Parking Lock | - | - |
Turn approximately 60° clockwise and release the parking lock.
If excessively large amounts of torque is applied, parts may be damaged.
If rotated in the opposite direction, parts may be damaged.
Turn the tool in the direction of its original position and return the outer lever to the original position.
Even after the tool is returned to its original position, the parking lock will stay released.
3. PARKING LOCK
After finishing the procedure, press the P position switch (parking switch) with the ignition switch ON to activate the parking lock.