Home › Drivetrain › Q710 (HYBRID TRANSMISSION / TRANSAXLE) › TRANSMISSION SHIFT MAIN SWITCH
RM37H0E _52 Drivetrain _093826 Q710 HYBRID TRANSMISSION / TRANSAXLE _0443098 TRANSMISSION SHIFT MAIN SWITCH G

Q710 HYBRID TRANSMISSION / TRANSAXLE  TRANSMISSION SHIFT MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84710A 1.INSPECT P POSITION SWITCH (PARKING SWITCH)

a.
C444747C01
2.76,0.396 3.156,0.604 0.396,0.208 2.271,1.365 2.458,1.365 2.458,1.365 2.802,1.604 true 2.302,2.021 2.969,2.021 2.969,2.021 3.063,1.844 true 0.052,0.042 0.292,0.302 0.24,0.26 10 false *a 2.115,1.302 2.271,1.5 0.156,0.198 10 false S 2.146,1.948 2.302,2.146 0.156,0.198 10 false E 2.833,0.438 3.167,0.656 0.333,0.219 10 false D17
*a Component without harness connected
(P Position Switch (Parking Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D17)Location & Routing

Click Connector(D17)Instrument Panel>Instrument Panel Wire>Parking Switch

D17-2 (S) - D17-9 (E) Switch ON 827 to 914 Ω
D17-2 (S) - D17-9 (E) Switch OFF 4190 to 4631 Ω


If the result is not as specified, replace the P position switch (parking switch).


b.
C444747C02
2.771,0.354 3.156,0.573 0.385,0.219 2.26,1.313 2.458,1.313 2.458,1.313 3.073,1.583 true 2.302,2.042 3.052,2.042 3.052,2.042 3.208,1.833 true 2.25,1.719 2.521,1.719 2.521,1.719 2.813,1.792 true 2.25,1.521 2.458,1.521 2.458,1.521 2.646,1.615 true 0.052,0.042 0.292,0.302 0.24,0.26 10 false *a 1.948,1.667 2.271,1.896 0.323,0.229 10 false IND+ 1.958,1.24 2.323,1.438 0.365,0.198 10 false IND- 1.958,1.458 2.26,1.635 0.302,0.177 10 false ILL+ 2.01,1.958 2.344,2.115 0.333,0.156 10 false ILL- 2.854,0.396 3.219,0.604 0.365,0.208 10 false D17
*a Component without harness connected
(P Position Switch (Parking Switch))


Apply battery voltage between the terminals of the P position switch (parking switch), and check the illumination condition of the P position switch (parking switch).

Standard:
Measurement Condition Specified Condition
Battery positive (+) → D17-7 (IND+)
Battery negative (-) → D17-4 (IND-)
Illuminates
Battery positive (+) → D17-1 (ILL+)
Battery negative (-) → D17-10 (ILL-)
Illuminates


If the result is not as specified, replace the P position switch (parking switch).