Home › Vehicle Interior › MIRROR (INT) › INNER REAR VIEW MIRROR (w/ EC Mirror)
RM37H0E _58 Vehicle Interior _095286 MIRROR (INT) _0448048 INNER REAR VIEW MIRROR(w/ EC Mirror) G

MIRROR (INT)  INNER REAR VIEW MIRROR(w/ EC Mirror)  INSPECTION  


PROCEDURE

Hide 87810 1.INSPECT INNER REAR VIEW MIRROR ASSEMBLY

a.

Inspect the operation of the electrochromic inner rear view mirror assembly.

B593131C02
3.281,0.115 3.615,0.323 0.333,0.208 3.563,0.969 3.813,1.219 3.813,1.219 3.979,1.219 true 3.688,0.958 4.021,0.958 true 1.427,2.156 1.76,2.156 true 0.729,1.885 0.729,2.323 true 6.031,2.052 6.031,2.302 true 4.094,0.885 4.406,1.083 0.313,0.198 10 false IG 4.083,1.146 4.396,1.344 0.313,0.198 10 false E 1.823,2.073 2.135,2.271 0.313,0.198 10 false *a 0.667,2.365 0.979,2.563 0.313,0.198 10 false *b 3.344,0.146 3.865,0.313 0.521,0.167 10 false H14 4.917,0.469 5.229,0.667 0.313,0.198 10 false *c 4.896,1.427 5.208,1.625 0.313,0.198 10 false *d 2.229,1.313 2.542,1.51 0.313,0.198 10 false *e 5.99,2.354 6.302,2.552 0.313,0.198 10 false *f 2.781,0.938 3.094,1.135 0.313,0.198 10 false *g
*a Black Colored Tape *b Forward Sensor
*c Bright *d Dark
*e Auxiliary Battery *f EC Switch
*g Component without harness connected
(Inner Rear View Mirror Assembly)
- -


i.

Connect a positive (+) lead from the auxiliary battery to terminal 1 (IG) and a negative (-) lead to terminal 2 (E).


ii.

Press the EC switch.


iii.

Attach black colored tape to the forward sensor to prevent it from sensing.


iv.

Light up the mirror with an electric light, and check that the mirror surface changes from bright to dark.

OK:
Tester Connection Condition Specified Condition

Click Location & Routing(H14)Location & Routing

Click Connector(H14)Body>No. 1 Roof Wire>Inner Rear View Mirror Assembly

H14-1(IG) - Auxiliary battery positive (+)
H14-2(E) - Auxiliary battery negative (-)
Light up the mirror with an electric light Inner rear view mirror surface Bright → Dark


If the result is not as specified, replace the inner rear view mirror assembly.