86150
1.INSPECT NO. 1 SPEAKER WITH BOX ASSEMBLY
With the speaker in the installed condition, check there are no abnormalities such looseness or rattling.
Check that there is no foreign matter inside the speaker.
Check that the speaker cone is not damaged.
| *a | Component without harness connected
(No. 1 Speaker With Box Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(G19)Location & Routingewd_type=routing;type=c;code=G19 Click Connector(G19)Body>Floor Wire / No. 3 Floor Wire>No. 1 Speaker with Box Assemblyewd_type=component;type=c;code=G19;pinno=1,2,3,4 |
||
| G19-1(WF2-) - G19-2(WF2+)
G19-3(WF1-) - G19-4(WF1+) |
Always | 4.3 to 6.5 Ω |
If the result is not as specified, replace the No. 1 speaker with box assembly.
86160Z
2.INSPECT REAR NO. 3 SPEAKER ASSEMBLY
With the speaker in the installed condition, check there are no abnormalities such looseness or rattling.
Check that there is no foreign matter inside the speaker.
Check that the speaker cone is not damaged.
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Rear No. 3 Speaker Assembly) |
for LH Side:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(G18)Location & Routingewd_type=routing;type=c;code=G18 Click Connector(G18)Body>Floor Wire / No. 3 Floor Wire>Rear No. 3 Speaker Assembly LHewd_type=component;type=c;code=G18;pinno=1,2 |
||
| G18-1(-) - G18-2(+) | Always | 2.8 to 3.8 Ω |
If the result is not as specified, replace the rear No. 3 speaker assembly.
| *a | Component without harness connected
(Rear No. 3 Speaker Assembly) |
for RH Side:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(G17)Location & Routingewd_type=routing;type=c;code=G17 Click Connector(G17)Body>Floor Wire / No. 3 Floor Wire>Rear No. 3 Speaker Assembly RHewd_type=component;type=c;code=G17;pinno=1,2 |
||
| G17-1(-) - G17-2(+) | Always | 2.8 to 3.8 Ω |
If the result is not as specified, replace the rear No. 3 speaker assembly.