84432
1.INSPECT VEHICLE SOUND SWITCH
| *a | Component without harness connected
(Vehicle Sound Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D106)Location & Routingewd_type=routing;type=c;code=D106 Click Connector(D106)Instrument Panel>Instrument Panel Wire>Vehicle Sound Switchewd_type=component;type=c;code=D106;pinno=5,2 |
||
| D106-5(B) - D106-2(ECU) | Vehicle sound switch on (not protruding) | Below 1 Ω |
| D106-5(B) - D106-2(ECU) | Vehicle sound switch off (protruding) | 10 kΩ or higher |
If the result is not as specified, replace the vehicle sound switch.
Check the indicator.
| *a | Component without harness connected
(Vehicle Sound Switch) |
Apply auxiliary battery voltage to the connector and check the illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(D106)Location & Routingewd_type=routing;type=c;code=D106 Click Connector(D106)Instrument Panel>Instrument Panel Wire>Vehicle Sound Switchewd_type=component;type=c;code=D106;pinno=5,4 |
|
| D106-5(B) - Auxiliary Battery positive (+)
D106-4(IND) - Auxiliary Battery negative (-) |
Illuminates |
If the result is not as specified, replace the vehicle sound switch.
Check the illumination.
| *a | Component without harness connected
(Vehicle Sound Switch) |
Apply auxiliary battery voltage to the connector and check the illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(D106)Location & Routingewd_type=routing;type=c;code=D106 Click Connector(D106)Instrument Panel>Instrument Panel Wire>Vehicle Sound Switchewd_type=component;type=c;code=D106;pinno=6,1 |
|
| D106-6(ILL+) - Auxiliary Battery positive (+)
D106-1(ILL-) - Auxiliary Battery negative (-) |
Illuminates |
If the result is not as specified, replace the vehicle sound switch.