86150B
1.INSPECT NO. 2 SPEAKER WITH BOX ASSEMBLY
| *a | Component without harness connected
(No. 2 Speaker With Box Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D4)Location & Routingewd_type=routing;type=c;code=D4 Click Connector(D4)Instrument Panel>Instrument Panel Wire>No. 2 Speaker with Box Assemblyewd_type=component;type=c;code=D4;pinno=1,2 |
||
| D4-1(SPI-) - D4-2(SPI+) | Always | 4 Ω |
If the result is not as specified, replace the No. 2 speaker with box assembly.