86150C
1.INSPECT NO. 3 SPEAKER WITH BOX ASSEMBLY
| *a | Component without harness connected
(No. 3 Speaker with Box Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D28)Location & Routingewd_type=routing;type=c;code=D28 Click Connector(D28)Instrument Panel>Instrument Panel Wire>No. 3 Speaker with Box Assemblyewd_type=component;type=c;code=D28;pinno=1,2 |
||
| D28-1(SPI-) - D28-2(SPI+) | Always | 4 Ω |
If the result is not as specified, replace the No. 3 speaker with box assembly.