Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH
RM37H0E _58 Vehicle Interior _095287 SUPPLEMENTAL RESTRAINT SYSTEMS _0448097 AIRBAG CUT-OFF SWITCH G

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG CUT-OFF SWITCH  INSPECTION  


PROCEDURE

Hide 69065A 1.INSPECT AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

a.
C234623C11
2.906,0.646 3.229,0.896 0.323,0.25 2.49,0.708 2.729,0.167 2.729,0.167 2.865,0.167 true 2.479,0.823 2.625,1.323 2.625,1.323 2.854,1.323 true 0.135,0.094 0.448,0.25 0.313,0.156 10 false *a 2.917,0.063 3.365,0.302 0.448,0.24 10 false PCM+ 2.906,1.229 3.313,1.438 0.406,0.208 10 false PCM- 2.948,0.688 3.281,0.875 0.333,0.188 10 false D47
*a Component without harness connected
(Airbag Cut Off Switch Cylinder Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(D47)Location & Routing

Click Connector(D47)Instrument Panel>Instrument Panel Wire>Airbag Cut Off Switch Cylinder Sub-Assembly

D47-1 (PCM-) - D47-2 (PCM+) Airbag cut off switch cylinder sub-assembly in ON 360 to 440 Ω
D47-1 (PCM-) - D47-2 (PCM+) Airbag cut off switch cylinder sub-assembly in OFF 90 to 110 Ω


If the result is not as specified, replace the airbag cut off switch cylinder sub-assembly.