87510R
1.INSPECT SEATBACK HEATER ASSEMBLY RH
| *a | Component without harness connected
(Seatback Heater Assembly RH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(M6)Location & Routingewd_type=routing;type=c;code=M6 Click Connector(M6)Seat>No. 1 Rear Seat Wire / No. 2 Rear Seat Wire>Rear Seat Heater Assembly RHewd_type=component;type=c;code=M6;pinno=1,2,3,4,5 |
||
| A-1 - M6-1 | Always 20°C (68°F) | Below 1 Ω |
| A-2 - M6-2 | Always 20°C (68°F) | Below 1 Ω |
| A-3 - M6-3 | Always 20°C (68°F) | Below 1 Ω |
| A-4 - M6-4 | Always 20°C (68°F) | Below 1 Ω |
| A-5 - M6-5 | Always 20°C (68°F) | Below 1 Ω |
| A-7 - M6-5 | Always 20°C (68°F) | 3.25 to 3.97 Ω |
If the result is not as specified, replace the seatback heater assembly RH.
87510S
2.INSPECT SEATBACK HEATER ASSEMBLY LH
| *a | Component without harness connected
(Seatback Heater Assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(M1)Location & Routingewd_type=routing;type=c;code=M1 Click Connector(M1)Seat>No. 1 Rear Seat Wire / No. 2 Rear Seat Wire>Rear Seat Heater Assembly LHewd_type=component;type=c;code=M1;pinno=1,2,3,4,5 |
||
| A-1 - M1-1 | Always 20°C (68°F) | Below 1 Ω |
| A-2 - M1-2 | Always 20°C (68°F) | Below 1 Ω |
| A-3 - M1-3 | Always 20°C (68°F) | Below 1 Ω |
| A-4 - M1-4 | Always 20°C (68°F) | Below 1 Ω |
| A-5 - M1-5 | Always 20°C (68°F) | Below 1 Ω |
| A-7 - M1-5 | Always 20°C (68°F) | 3.25 to 3.97 Ω |
If the result is not as specified, replace the seatback heater assembly LH.