Home › Vehicle Interior › SEAT › OCCUPANT DETECTION SENSOR (for Rear Seat)
RM37H0E _58 Vehicle Interior _095292 SEAT _0448138 OCCUPANT DETECTION SENSOR(for Rear Seat) G

SEAT  OCCUPANT DETECTION SENSOR(for Rear Seat)  INSPECTION  


PROCEDURE

Hide 71503A 1.INSPECT REAR SEAT CUSHION PAD SUB-ASSEMBLY (OCCUPANT DETECTION SENSOR)

a.

for LH:

i.
E118525C13
0.177,0.188 0.49,0.344 0.313,0.156 10 false *a
*a Component without harness connected
(Rear Seat Cushion Pad Sub-assembly (Occupant Detection Sensor))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Occupied Below 100 Ω
1 - 2 Not occupied 1 MΩ or higher


If the result is not as specified, replace the rear seat cushion pad sub-assembly (occupant detection sensor).



b.

for Center:

i.
E118525C13
0.177,0.188 0.49,0.344 0.313,0.156 10 false *a
*a Component without harness connected
(Rear Seat Cushion Pad Sub-assembly (Occupant Detection Sensor))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Occupied Below 100 Ω
1 - 2 Not occupied 1 MΩ or higher


If the result is not as specified, replace the rear seat cushion pad sub-assembly (occupant detection sensor).



c.

for RH:

i.
E118525C13
0.177,0.188 0.49,0.344 0.313,0.156 10 false *a
*a Component without harness connected
(Rear Seat Cushion Pad Sub-assembly (Occupant Detection Sensor))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Occupied Below 100 Ω
1 - 2 Not occupied 1 MΩ or higher


If the result is not as specified, replace the rear seat cushion pad sub-assembly (occupant detection sensor).