73470B
1.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH
| *a | Component without harness connected
(Rear Seat Inner with Center Belt Assembly RH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(G77)Location & Routingewd_type=routing;type=c;code=G77 Click Connector(G77)Seat>Floor Wire>Rear Seat Inner Belt with Center Assembly RHewd_type=component;type=c;code=G77;pinno=1,2 |
||
| G77-1 (RBR+) - G77-2 (RBR-) | Seat belt fastened | 10 kΩ or higher |
| G77-1 (RBR+) - G77-2 (RBR-) | Seat belt unfastened | Below 1 Ω |
If the result is not as specified, replace the rear seat inner with center belt assembly RH.
73480A
2.INSPECT REAR SEAT INNER BELT ASSEMBLY LH
for LH Seat:
| *a | Component without harness connected
(Rear Seat Inner Belt Assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(G78)Location & Routingewd_type=routing;type=c;code=G78 Click Connector(G78)Seat>Floor Wire>Rear Seat Inner Belt Assembly LHewd_type=component;type=c;code=G78;pinno=1,2 |
||
| G78-1 (LBR+) - G78-2 (LBR-) | Seat belt fastened | 10 kΩ or higher |
| G78-1 (LBR+) - G78-2 (LBR-) | Seat belt unfastened | Below 1 Ω |
If the result is not as specified, replace the rear seat inner belt assembly LH.
for Center Seat:
| *a | Component without harness connected
(Rear Seat Inner Belt Assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(G75)Location & Routingewd_type=routing;type=c;code=G75 Click Connector(G75)Seat>Floor Wire>Rear Seat Inner Belt Assembly LHewd_type=component;type=c;code=G75;pinno=1,2 |
||
| G75-1 (CBR+) - G75-2 (CBR-) | Seat belt fastened | 10 kΩ or higher |
| G75-1 (CBR+) - G75-2 (CBR-) | Seat belt unfastened | Below 1 Ω |
If the result is not as specified, replace the rear seat inner belt assembly LH.