53510
1.INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)
| *a | Engine hood close |
| *b | Engine hood open |
| *c | Component without harness connected
(Engine Hood Courtesy Switch (Hood Lock assembly)) |
for LHD:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A4)Location & Routingewd_type=routing;type=c;code=A4 Click Connector(A4)Engine Compartment>Front Compartment Main Wire / No. 3 Front Compartment Wire / No. 4 Front Compartment Wire>Hood Lock Assemblyewd_type=component;type=c;code=A4;pinno=1,2 |
||
| A4-1(E) - A4-2(+) | Open | 10 kΩ or higher |
| A4-1(E) - A4-2(+) | Close | Below 1 Ω |
If the result is not as specified, replace the engine hood courtesy switch (hood lock assembly).
| *a | Engine hood close |
| *b | Engine hood open |
| *c | Component without harness connected
(Engine Hood Courtesy Switch (Hood Lock assembly)) |
for RHD:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A4)Location & Routingewd_type=routing;type=c;code=A4 Click Connector(A4)Engine Compartment>Front Compartment Main Wire / No. 3 Front Compartment Wire / No. 4 Front Compartment Wire>Hood Lock Assemblyewd_type=component;type=c;code=A4;pinno=1,2 |
||
| A4-1(E) - A4-2(+) | Open | 10 kΩ or higher |
| A4-1(E) - A4-2(+) | Close | Below 1 Ω |
If the result is not as specified, replace the engine hood courtesy switch (hood lock assembly).