84040
1.INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
Check the illumination.
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |
for LHD:
Apply auxiliary battery voltage to the connector and check the illumination conditions
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(E32)Location & Routingewd_type=routing;type=c;code=E32 Click Connector(E32)Body>Front Door Wire LH / Front Door Wire RH>Multiplex Network Master Switch Assemblyewd_type=component;type=c;code=E32;pinno=3,13 |
|
| E32-3 (ILL+) - Auxiliary battery positive (+)
E32-13 (ILL-) - Auxiliary battery negative (-) |
Illuminates |
If the result is not as specified, replace the multiplex network master switch assembly.
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |
for RHD:
Apply auxiliary battery voltage to the connector and check the illumination conditions.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(E14)Location & Routingewd_type=routing;type=c;code=E14 Click Connector(E14)Body>Front Door Wire LH / Front Door Wire RH>Multiplex Network Master Switch Assemblyewd_type=component;type=c;code=E14;pinno=3,13 |
|
| E14-3 (ILL+) - Auxiliary battery positive (+)
E14-13 (ILL-) - Auxiliary battery negative (-) |
Illuminates |
If the result is not as specified, replace the multiplex network master switch assembly.