Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER WIRE
RM37H0E _59 Vehicle Exterior _095305 WINDOW / GLASS _0448202 WINDOW DEFOGGER WIRE A

WINDOW / GLASS  WINDOW DEFOGGER WIRE  REPAIR  


PROCEDURE

Hide 64810 1.REPAIR BACK WINDOW ASSEMBLY (REAR WINDOW DEFOGGER WIRE)

B106758C26
1.052,0.573 0.5,1.083 0.5,1.083 1.104,1.01 true 1.729,0.917 1.729,1.313 true 2.833,0.875 2.833,1.115 false 1.635,1.333 1.844,1.563 0.208,0.229 10 false *c 0.333,1.042 0.542,1.25 0.208,0.208 10 false *a 2.75,1.146 2.969,1.354 0.219,0.208 10 false *b
*a Masking Tape
*b Broken Wire
*c Repair Point


a.

Clean the broken wire tips with a grease, wax and silicone remover.


b.

Place masking tape along both sides of the wire.


c.
B106759

Thoroughly mix the repair agent.


d.

Using a fine tip brush, apply a small amount of the agent to the wire.


e.

After a few minutes, remove the masking tape.

NOTICE:

Do not use the rear window defogger for at least 24 hours after performing the repair.