81340
1.INSPECT VANITY LIGHT ASSEMBLY (for LH Side)
| *a | Component without harness connected
(Vanity Light Assembly) |
Check the illumination.
Apply auxiliary battery voltage to the vanity light assembly and check that the vanity light comes on.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(H2)Location & Routingewd_type=routing;type=c;code=H2 Click Connector(H2)Body>No. 1 Roof Wire>Vanity Light Assembly LHewd_type=component;type=c;code=H2;pinno=2,1 |
|
| H2-2 (B) → Auxiliary battery positive (+)
H2-1 (E) → Auxiliary battery negative (-) |
Vanity light illuminates |
If the result is not as specified, replace the vanity light assembly.
81340
2.INSPECT VANITY LIGHT ASSEMBLY (for RH Side)
| *a | Component without harness connected
(Vanity Light Assembly) |
Check the illumination.
Apply auxiliary battery voltage to the vanity light assembly and check that the vanity light comes on.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(H11)Location & Routingewd_type=routing;type=c;code=H11 Click Connector(H11)Body>No. 1 Roof Wire>Vanity Light Assembly RHewd_type=component;type=c;code=H11;pinno=2,1 |
|
| H11-2 (B) - Auxiliary battery positive (+)
H11-1 (E) - Auxiliary battery negative (-) |
Vanity light illuminates |
If the result is not as specified, replace the vanity light assembly.