81330
1.INSPECT NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
| *a | Component without harness connected
(No. 1 Luggage Compartment Light Assembly) |
Check the illumination.
Apply auxiliary battery voltage to the connector and check that the light illuminate.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(G10)Location & Routingewd_type=routing;type=c;code=G10 Click Connector(G10)Body>Floor Wire / No. 3 Floor Wire>No. 1 Luggage Compartment Light Assemblyewd_type=component;type=c;code=G10;pinno=2,1 |
|
| G10-2 (B) - Auxiliary battery positive (+)
G10-1 (L) - Auxiliary battery negative (-) |
Illuminates |
If the result is not as specified, replace the No. 1 luggage compartment light assembly.