84233
1.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (for LH Side)
| *a | Component without harness connected
(Front Door Courtesy Light Switch Assembly) |
Inspect the front door courtesy light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(G62)Location & Routingewd_type=routing;type=c;code=G62 Click Connector(G62)Body>Floor Wire / No. 3 Floor Wire>Front Door Courtesy Light Switch Assembly LHewd_type=component;type=c;code=G62;pinno=1 |
||
| G62-1 - Switch body | Pushed | 10 kΩ or higher |
| G62-1 - Switch body | Not pushed | Below 1 Ω |
Connect the negative (-) tester lead near the bolt hole.
If the result is not as specified, replace the front door courtesy light switch assembly.
84233
2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (for RH Side)
| *a | Component without harness connected
(Front Door Courtesy Light Switch Assembly) |
Inspect the front door courtesy light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(G39)Location & Routingewd_type=routing;type=c;code=G39 Click Connector(G39)Body>Floor Wire / No. 3 Floor Wire>Front Door Courtesy Light Switch Assembly RHewd_type=component;type=c;code=G39;pinno=1 |
||
| G39-1 - Switch body | Pushed | 10 kΩ or higher |
| G39-1 - Switch body | Not pushed | Below 1 Ω |
Connect the negative (-) tester lead near the bolt hole.
If the result is not as specified, replace the front door courtesy light switch assembly.