Home › Vehicle Interior › LIGHTING (INT) › REAR DOOR COURTESY SWITCH
RM37H0E _58 Vehicle Interior _095306 LIGHTING (INT) _0448210 REAR DOOR COURTESY SWITCH G

LIGHTING (INT)  REAR DOOR COURTESY SWITCH  INSPECTION  


PROCEDURE

Hide 84234 1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (for LH Side)

a.
E245717C39
1.521,0.281 1.865,0.521 0.344,0.24 0.177,0.083 0.51,0.406 0.333,0.323 10 false *a 1.563,0.323 2.021,0.521 0.458,0.198 10 false G66
*a Component without harness connected
(Rear Door Courtesy Light Switch Assembly)


Inspect the rear door courtesy light switch assembly.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(G66)Location & Routing

Click Connector(G66)Body>Floor Wire / No. 3 Floor Wire>Rear Door Courtesy Light Switch Assembly LH

G66-1 - Switch body Pushed 10 kΩ or higher
G66-1 - Switch body Not pushed Below 1 Ω


HINT:

Connect the negative (-) tester lead near the bolt hole.


If the result is not as specified, replace the rear door courtesy light switch assembly.


Hide 84234 2.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (for RH Side)

a.
E245717C40
1.521,0.281 1.865,0.521 0.344,0.24 0.177,0.083 0.51,0.406 0.333,0.323 10 false *a 1.563,0.313 2.021,0.51 0.458,0.198 10 false G44
*a Component without harness connected
(Rear Door Courtesy Light Switch Assembly)


Inspect the rear door courtesy light switch assembly.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(G44)Location & Routing

Click Connector(G44)Body>Floor Wire / No. 3 Floor Wire>Rear Door Courtesy Light Switch Assembly RH

G44-1 - Switch body Pushed 10 kΩ or higher
G44-1 - Switch body Not pushed Below 1 Ω


HINT:

Connect the negative (-) tester lead near the bolt hole.


If the result is not as specified, replace the rear door courtesy light switch assembly.