81080S
1.INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY LH
| *a | Component without harness connected
(No. 1 Interior Illumination Light Assembly LH) |
Check the illumination.
Apply auxiliary battery voltage to the connector and check that the light illuminate.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(D18)Location & Routingewd_type=routing;type=c;code=D18 Click Connector(D18)Instrument Panel>Instrument Panel Wire>Driver Side Foot Light (No. 1 Interior Illumination Light Assembly)ewd_type=component;type=c;code=D18;pinno=2,1 |
|
| D18-2 (B) - Auxiliary battery positive (+)
D18-1 (L) - Auxiliary battery negative (-) |
Illuminates |
If the result is not as specified, replace the No. 1 interior illumination light assembly LH.