Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM37H0E _59 Vehicle Exterior _093353 LIGHTING (EXT) _0448249 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E166833C08
1.458,0.333 1.958,0.583 0.5,0.25 1.344,1.583 1.594,1.229 true 2.063,1.583 1.802,1.229 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 1.219,1.625 1.531,1.781 0.313,0.156 10 false TB 2.094,1.625 2.406,1.781 0.313,0.156 10 false E 1.573,0.385 2.031,0.583 0.458,0.198 10 false D99
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Inspect the hazard warning signal switch assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(D99)Location & Routing

Click Connector(D99)Instrument Panel>Instrument Panel Wire>Hazard Warning Signal Switch Assembly

D99-5(TB) - D99-4(E) Hazard warning signal switch OFF 10 kΩ or higher
D99-5(TB) - D99-4(E) Hazard warning signal switch ON Below 1 Ω


HINT:

If the result is not as specified, replace the hazard warning signal switch assembly.




b.
E166833C09
1.458,0.333 1.958,0.583 0.5,0.25 1.198,1.583 1.448,1.229 true 2.219,1.583 1.958,1.229 true 0.104,0.094 0.417,0.25 0.313,0.156 10 false *a 1.052,1.604 1.365,1.76 0.313,0.156 10 false ILL+ 2.146,1.615 2.458,1.771 0.313,0.156 10 false ILL- 1.583,0.385 2.042,0.583 0.458,0.198 10 false D99
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Check the illumination.

i.

Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the lights illuminate.

OK:
Tester Connection Specified Condition

Click Location & Routing(D99)Location & Routing

Click Connector(D99)Instrument Panel>Instrument Panel Wire>Hazard Warning Signal Switch Assembly

Auxiliary battery positive (+) - Terminal D99-6(ILL+)
Auxiliary battery positive (+) - D99-3(ILL-)
Hazard warning signal switch assembly illuminates


HINT:

If the result is not as specified, replace the hazard warning signal switch assembly.