81536J
1.INSPECT FRONT TURN SIGNAL LIGHT LED (for LH Side, w/ Adaptive High Beam System)
Check the illumination.
| *a | Component without harness connected
(Front Turn Signal Light LED) |
Apply auxiliary battery voltage to the front turn signal light LED and check that the light illuminates.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(A91)Location & Routingewd_type=routing;type=c;code=A91 |
|
| Auxiliary battery positive (+) → Terminal A91-1(B)
Auxiliary battery negative (-) → Terminal A91-2(E) |
Front turn signal light LED illuminates |
If the result is not as specified, replace the front turn signal light LED assembly.
81536J
2.INSPECT FRONT TURN SIGNAL LIGHT LED (for RH Side, w/ Adaptive High Beam System)
Check the illumination.
| *a | Component without harness connected
(Front Turn Signal Light LED) |
Apply auxiliary battery voltage to the front turn signal light LED and check that the light illuminates.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(A90)Location & Routingewd_type=routing;type=c;code=A90 |
|
| Auxiliary battery positive (+) → Terminal A90-1(B)
Auxiliary battery negative (-) → Terminal A90-2(E) |
Front turn signal light LED illuminates |
If the result is not as specified, replace the front turn signal light LED assembly.
81520
3.INSPECT FRONT TURN SIGNAL LIGHT ASSEMBLY LH (w/o Adaptive High Beam System)
Check the illumination.
| *a | Component without harness connected
(Front Turn Signal Light assembly LH) |
Apply auxiliary battery voltage to the front turn signal light assembly LH and check that the light illuminates.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(A93)Location & Routingewd_type=routing;type=c;code=A93 |
|
| Auxiliary battery positive (+) → Terminal A93-2(B)
Auxiliary battery negative (-) → Terminal A93-1(E) |
Front turn signal light assembly LH illuminates |
If the result is not as specified, replace the front turn signal light assembly LH.
81510
4.INSPECT FRONT TURN SIGNAL LIGHT ASSEMBLY RH (w/o Adaptive High Beam System)
Check the illumination.
| *a | Component without harness connected
(Front Turn Signal Light assembly RH) |
Apply auxiliary battery voltage to the front turn signal light assembly RH and check that the light illuminates.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(A92)Location & Routingewd_type=routing;type=c;code=A92 |
|
| Auxiliary battery positive (+) → Terminal A92-2(B)
Auxiliary battery negative (-) → Terminal A92-1(E) |
Front turn signal light assembly RH illuminates |
If the result is not as specified, replace the front turn signal light assembly RH.