81360T
1.INSPECT SPOT LIGHT ASSEMBLY
Check the illumination.
| *a | Component without harness connected
(Spot Light Assembly) |
Apply auxiliary battery voltage to the connector and check the light illumination condition.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H19)Location & Routingewd_type=routing;type=c;code=H19 Click Connector(H19)Body>No. 1 Roof Wire>Spot Light Assemblyewd_type=component;type=c;code=H19;pinno=5,1,2 |
||
| H19-5 (B) - Auxiliary battery positive (+)
H19-1 (E) - Auxiliary battery negative (-) |
Spot light switch LH ON | Spot light LH illuminates |
| Spot light switch RH ON | Spot light RH illuminates | |
| H19-5 (B) - Auxiliary battery positive (+)
H19-2 (CTY) - Auxiliary battery negative (-) |
Spot light switch LH OFF | Spot light LH illuminates |
| Spot light switch RH OFF | Spot light RH illuminates | |
If the result is not as specified, replace the spot light assembly.