88625Q
1.INSPECT COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)
| *a | Component without harness connected
(Cooler Thermistor (Room Temperature Sensor)) |
| *b | Sensing Portion |
| *c | Resistance (kΩ) |
| *d | Temperature (°C (°F)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D45)Location & Routingewd_type=routing;type=c;code=D45 Click Connector(D45)Instrument Panel>Instrument Panel Wire>Cooler (Room Temperature Sensor) Thermistorewd_type=component;type=c;code=D45;pinno=1,2 |
||
| D45-1 (+) - D45-2 (-) | 10°C (50°F) | 3.00 to 3.73 kΩ |
| D45-1 (+) - D45-2 (-) | 15°C (59°F) | 2.45 to 2.88 kΩ |
| D45-1 (+) - D45-2 (-) | 20°C (68°F) | 1.95 to 2.30 kΩ |
| D45-1 (+) - D45-2 (-) | 25°C (77°F) | 1.60 to 1.80 kΩ |
| D45-1 (+) - D45-2 (-) | 30°C (86°F) | 1.28 to 1.47 kΩ |
| D45-1 (+) - D45-2 (-) | 35°C (95°F) | 1.00 to 1.22 kΩ |
| D45-1 (+) - D45-2 (-) | 40°C (104°F) | 0.80 to 1.00 kΩ |
| D45-1 (+) - D45-2 (-) | 45°C (113°F) | 0.65 to 0.85 kΩ |
| D45-1 (+) - D45-2 (-) | 50°C (122°F) | 0.50 to 0.70 kΩ |
| D45-1 (+) - D45-2 (-) | 55°C (131°F) | 0.44 to 0.60 kΩ |
| D45-1 (+) - D45-2 (-) | 60°C (140°F) | 0.36 to 0.50 kΩ |
Hold the sensor only by its connector. Touching the sensing portion may change the resistance value.
When measuring, the sensor temperature must be the same as the ambient temperature.
As the temperature increases, the resistance decreases (see the graph).
If the result is not as specified, replace the cooler thermistor (room temperature sensor).