DATA LIST
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ACC SW | Ignition switch ACC signal | OFF or ON | ON: Ignition switch ACC
OFF: Ignition switch off |
"ON" is also displayed for this item when the ignition switch is ON. |
| IG SW | Ignition switch ON signal | OFF or ON | ON: Ignition switch ON
OFF: Ignition switch off |
"OFF" is also displayed for this item when the ignition switch is ACC. |
| RR Door Courtesy SW | Rear door courtesy light switch assembly RH signal | OFF or ON | OFF: Rear door RH closed
ON: Rear door RH open |
- |
| RL Door Courtesy SW | Rear door courtesy light switch assembly LH signal | OFF or ON | OFF: Rear door LH closed
ON: Rear door LH open |
- |
| FR Door Lock Pos | Front door RH unlock detection switch signal | LOCK or UNLOCK | LOCK: Front door RH locked
UNLOCK: Front door RH unlocked |
- |
| FR Door Courtesy SW | Front door courtesy light switch assembly RH signal | OFF or ON | OFF: Front door RH closed
ON: Front door RH open |
- |
| FL Door Lock Pos | Front door LH unlock detection switch signal | LOCK or UNLOCK | LOCK: Front door LH locked
UNLOCK: Front door LH unlocked |
- |
| FL Door Courtesy SW | Front door courtesy light switch assembly LH signal | OFF or ON | OFF: Front door LH closed
ON: Front door LH open |
- |
| Dome Light DOOR SW | Map light assembly (door switch) signal | OFF or ON | OFF: Map light assembly (door switch) off
ON: Map light assembly (door switch) on |
- |
| Dome Light SW | Map light assembly (touch lens switch) signal | OFF or ON | OFF: Map light assembly (touch lens switch) off
ON: Map light sub-assembly (touch lens switch) on |
- |
| RR-Door Lock Pos SW | Rear door RH unlock detection switch signal | OFF or ON | OFF: Rear door RH unlocked
ON: Rear door RH locked |
- |
| RL-Door Lock Pos SW | Rear door LH unlock detection switch signal | OFF or ON | OFF: Rear door LH unlocked
ON: Rear door LH locked |
- |
| Luggage Courtesy SW | Luggage compartment door courtesy switch signal | OFF or ON | OFF: Luggage compartment door closed
ON: Luggage compartment door open |
- |
| Interior Light Control | Operation of the illuminated entry system | OFF or ON | Customized setting displayed | - |
| I/L ON W/Door Key Unlock | Function that turns on the interior lights when the doors are unlocked | OFF or ON | Customized setting displayed | - |
| Lighting Time | Lighting time of the delay control function (illuminated entry system) | 15s, 7.5s or 30s | Customized setting displayed | - |
| Room Light when Aprchd | Function that lights up the interior lights when a key enters any actuation area | OFF or ON | Customized setting displayed | - |
| Inside Foot Light | Function that lights up the No. 1 interior illumination light assembly (footwell light) | OFF or ON | Customized setting displayed | - |
| I/L when ACC OFF | Function that lights up the interior lights when the ignition switch is turned from ACC or ON to off | OFF or ON | Customized setting displayed | - |
| Light Control | Function that dims the following lights when the ignition switch is ON and the shift lever is moved to any position other than P:
·
No. 1 interior illumination light assembly LH (front footwell light) ·
No. 1 interior illumination light assembly RH (front footwell light) ·
No. 3 interior illumination light assembly (rear footwell light LH)*1 ·
No. 3 interior illumination light assembly (rear footwell light RH)*1 ·
No. 1 interior illumination light assembly (front inside handle illumination LH)*2 ·
No. 1 interior illumination light assembly (front inside handle illumination RH)*2 ·
No. 1 interior illumination light assembly (rear inside handle illumination LH)*2 ·
No. 1 interior illumination light assembly (rear inside handle illumination RH)*2 ·
No. 2 interior illumination light assembly (front door ornament illumination LH)*2 ·
No. 2 interior illumination light assembly (front door ornament illumination RH)*2 ·
No. 2 interior illumination light assembly (rear door ornament illumination RH)*2 ·
No. 2 interior illumination light assembly (rear door ornament illumination LH)*2 ·
No. 1 instrument panel sub-assembly*2 ·
No. 1 interior illumination light assembly (cup holder light) |
OFF or ON | Customized setting displayed | - |
| Interior Illumination Light | Function that turns on the following lights:
·
No. 1 interior illumination light assembly LH (front footwell light) ·
No. 1 interior illumination light assembly RH (front footwell light) ·
No. 3 interior illumination light assembly (rear footwell light LH)*1 ·
No. 3 interior illumination light assembly (rear footwell light RH)*1 ·
No. 1 interior illumination light assembly (front inside handle illumination LH)*2 ·
No. 1 interior illumination light assembly (front inside handle illumination RH)*2 ·
No. 1 interior illumination light assembly (rear inside handle illumination LH)*2 ·
No. 1 interior illumination light assembly (rear inside handle illumination RH)*2 ·
No. 2 interior illumination light assembly (front door ornament illumination LH)*2 ·
No. 2 interior illumination light assembly (front door ornament illumination RH)*2 ·
No. 2 interior illumination light assembly (rear door ornament illumination RH)*2 ·
No. 2 interior illumination light assembly (rear door ornament illumination LH)*2 ·
No. 1 instrument panel sub-assembly*2 ·
No. 1 interior illumination light assembly (cup holder light) |
OFF or ON | Customized setting displayed | - |
*1: w/ Rear Footwell Light
*2: w/ Inside Handle Illumination Light
ACTIVE TEST
Using the GTS, perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Illuminated Entry System | Turns on the lights that are controlled by the illuminated entry system*1 | OFF or ON | Perform the Active Test with DOOR switch in the map light assembly and spot light assembly turned on. |
| Fr Foot Light | Operation of the following lights:
·
No. 1 interior illumination light assembly LH (front footwell light) ·
No. 1 interior illumination light assembly RH (front footwell light) ·
No. 3 interior illumination light assembly (rear footwell light LH)*2 ·
No. 3 interior illumination light assembly (rear footwell light RH)*2 ·
No. 1 interior illumination light assembly (front inside handle illumination LH)*3 ·
No. 1 interior illumination light assembly (front inside handle illumination RH)*3 ·
No. 1 interior illumination light assembly (rear inside handle illumination LH)*3 ·
No. 1 interior illumination light assembly (rear inside handle illumination RH)*3 ·
No. 2 interior illumination light assembly (front door ornament illumination LH)*3 ·
No. 2 interior illumination light assembly (front door ornament illumination RH)*3 ·
No. 2 interior illumination light assembly (rear door ornament illumination RH)*3 ·
No. 2 interior illumination light assembly (rear door ornament illumination LH)*3 ·
Instrument panel sub-assembly*3 ·
No. 1 interior illumination light assembly (cup holder light)*3 |
OFF or ON | - |
| Relay for Interior Light Auto Cut Function | DOME CUT D relay | ON or OFF | When performing this Active Test, turn all the interior lights on.
·
OFF: DOME CUT D relay on (interior lights turn on) ·
ON: DOME CUT D relay off (interior lights turn off) |
| Interior Illumination Light1 | Illuminates the following lights:
·
No. 1 interior illumination light assembly (cup holder illumination) |
OFF or ON | - |
| Dimmer Signal | Outputs night mode (dimmer signal) | OFF or ON | - |
*1: Refer to Operation Check for the lights that are controlled by the illuminated entry system.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>OPERATION CHECK
*2: w/ Rear Footwell Light
*3: w/ Inside Handle Illumination
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Power/Engine SW Light | Push Start switch illumination | OFF or ON | - |