Home › ADAS / AD › ADVANCED DRIVER ASSISTANCE SYSTEM › AUTOMATIC HIGH BEAM SYSTEM
RM37H0E _95 ADAS / AD _095317 ADVANCED DRIVER ASSISTANCE SYSTEM _0448418 AUTOMATIC HIGH BEAM SYSTEM T

ADVANCED DRIVER ASSISTANCE SYSTEM  AUTOMATIC HIGH BEAM SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

When the forward recognition camera is replaced with a new one, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

for Sequential Recognition:

Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

for One Time Recognition:

Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

for Driving Adjustment:

Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>DRIVING ADJUSTMENT


·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



Automatic High Beam System
Symptom Suspected Area Link
Automatic high beam system does not operate or automatic high beam indicator does not illuminate (low beam headlights and high beam headlights are normal) Check millimeter wave radar sensor assembly Click here
Check Data List (Front Recognition Camera High Temperature 2)
Check automatic high beam indicator light
Check Data List (Auto H Beam STS)
Check Data List (Auto High Beam Main Switch)
Check Active Test (Automatic High Beam Indicator (Green))
Check automatic high beam main switch
Harness or connector
Combination meter assembly
Forward recognition camera
Main body ECU (multiplex network body ECU)
Auto high beam switch indicator does not come ON Refer to "Automatic High Beam Switch Indicator does not Come ON" Click here