Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM37H0E _59 Vehicle Exterior _093353 LIGHTING (EXT) _0448416 LIGHTING SYSTEM C

LIGHTING (EXT)  LIGHTING SYSTEM  U0073  Control Module Communication Bus Off  U0126  Lost Communication with Steering Angle Sensor Module  U0142  Lost Communication with Body Control Module "B"  U0155  Lost Communication with Instrument Panel Cluster (IPC) Control Module  U0182  Lost Communication With Lighting Control Module Front  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
U0073 Control Module Communication Bus Off The headlight ECU sub-assembly RH does not send/receive data. CAN communication system AFS (Sub) B w/ Adaptive High Beam System
U0126 Lost Communication with Steering Angle Sensor Module The headlight ECU sub-assembly RH does not receive data from the steering sensor for approximately 10 seconds or more. CAN communication system AFS (Sub) B w/ Adaptive High Beam System
U0142 Lost Communication with Body Control Module "B" The headlight ECU sub-assembly RH does not receive data from the main body ECU (multiplex network body ECU) for approximately 10 seconds or more. CAN communication system AFS (Sub) B w/ Adaptive High Beam System
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module The headlight ECU sub-assembly RH does not receive data from the combination meter assembly circuit plate for approximately 10 seconds or more. CAN communication system AFS (Sub) B w/ Adaptive High Beam System
U0182 Lost Communication With Lighting Control Module Front The headlight ECU sub-assembly RH does not receive data from the headlight ECU sub-assembly LH circuit plate for approximately 10 seconds or more. CAN communication system AFS (Sub) B w/ Adaptive High Beam System

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
U0073 Control Module Communication Bus Off The headlight ECU sub-assembly RH does not send/receive data. CAN communication system HL AutoLeveling (Sub) B w/o Adaptive High Beam System
U0126 Lost Communication with Steering Angle Sensor Module The headlight ECU sub-assembly RH does not receive data from the steering sensor for approximately 10 seconds or more. CAN communication system HL AutoLeveling (Sub) B w/o Adaptive High Beam System
U0142 Lost Communication with Body Control Module "B" The headlight ECU sub-assembly RH does not receive data from the main body ECU (multiplex network body ECU) for approximately 10 seconds or more. CAN communication system HL AutoLeveling (Sub) B w/o Adaptive High Beam System
U0155 Lost Communication with Instrument Panel Cluster (IPC) Control Module The headlight ECU sub-assembly RH does not receive data from the combination meter assembly circuit plate for approximately 10 seconds or more. CAN communication system HL AutoLeveling (Sub) B w/o Adaptive High Beam System
U0182 Lost Communication With Lighting Control Module Front The headlight ECU sub-assembly RH does not receive data from the headlight ECU sub-assembly LH circuit plate for approximately 10 seconds or more. CAN communication system HL AutoLeveling (Sub) B w/o Adaptive High Beam System

PROCEDURE

1.CHECK VEHICLE TYPE
a.

Check vehicle condition.


Result:
Result Proceed to
w/ Adaptive High Beam System A
w/o Adaptive High Beam System B



A

2.CLEAR DTC

B

4.CLEAR DTC
2.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Body Electrical > AFS (Sub) > Clear DTCs
50002 413
Result:
Proceed to
NEXT



Post-procedure1

a.

None



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

Pre-procedure1

a.

Turn the ignition switch ON and wait for at least 10 seconds or more.


Procedure1

a.

Check for DTCs.

Body Electrical > AFS (Sub) > Trouble Codes
50001 413
Result:
Result Proceed to
U0073, U0126, U0142, U0155 and U0182 are not output A
U0073, U0126, U0142, U0155 or U0182 is output B



Post-procedure1

a.

None



A

B

4.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Body Electrical > HL AutoLeveling (Sub) > Clear DTCs
50002 414
Result:
Proceed to
NEXT



Post-procedure1

a.

None



NEXT

5.CHECK FOR DTC
5.CHECK FOR DTC

Pre-procedure1

a.

Turn the ignition switch ON and wait for at least 10 seconds or more.


Procedure1

a.

Check for DTCs.

Body Electrical > HL AutoLeveling (Sub) > Trouble Codes
50001 414
Result:
Result Proceed to
U0073, U0126, U0142, U0155 and U0182 are not output A
U0073, U0126, U0142, U0155 or U0182 is output B



Post-procedure1

a.

None



A

B