Home › Vehicle Exterior › WINDOW / GLASS › WINDSHIELD DEICER SWITCH
RM37H0E _59 Vehicle Exterior _095305 WINDOW / GLASS _0449254 WINDSHIELD DEICER SWITCH G

WINDOW / GLASS  WINDSHIELD DEICER SWITCH  INSPECTION  


PROCEDURE

Hide 84794 1.INSPECT FRONT WIPER DEICER SWITCH (w/ Navigation System)

a.

Inspect the front wiper deicer switch.

i.
E455887C01
1.469,0.26 1.917,0.469 0.448,0.208 1.969,1.635 1.969,1.302 true 1.458,1.635 1.458,1.302 true 0.104,0.094 0.417,0.292 0.313,0.198 10 false *a 1.417,1.646 1.677,1.854 0.26,0.208 10 false IG 1.875,1.646 2.24,1.802 0.365,0.156 10 false ECU 1.552,0.302 2.01,0.5 0.458,0.198 10 false D108
*a Component without harness connected
(Front Wiper Deicer Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(D108)Location & Routing

Click Connector(D108)Instrument Panel>Instrument Panel Wire>Front Wiper Deicer Switch

D108-2(ECU) - D108-5(IG) Front wiper deicer switch off 10 kΩ or higher
D108-2(ECU) - D108-5(IG) Front wiper deicer switch on Below 1 Ω


If the result is not as specified, replace the front wiper deicer switch.



b.

Check the illumination.

i.
E455888C02
2.365,0.385 2.771,0.583 0.406,0.198 3.01,1.323 3.01,1.656 true 2.167,1.333 2.167,1.667 true 1.375,0.313 0.875,0.313 0.875,0.313 0.875,1.021 false 2.958,1.688 3.292,1.854 0.333,0.167 10 false ILL- 0.094,0.104 0.406,0.302 0.313,0.198 10 false *a 2.094,1.677 2.708,1.875 0.615,0.198 10 false ILL+ 1.417,0.26 1.729,0.458 0.313,0.198 10 false *b 2.427,0.417 2.885,0.615 0.458,0.198 10 false D108
*a Component without harness connected
(Front Wiper Deicer Switch)
*b Illuminates


Apply battery voltage to the connector and check the illumination conditions.

OK:
Battery Connection Specified Condition
Auxiliary Battery positive → 6(ILL+)
Auxiliary Battery negative → 1(ILL-)
Illuminates


If the result is not as specified, replace the front wiper deicer switch.



c.

Check the indicator light illuminates.

i.
E455888C01
2.344,0.313 2.75,0.51 0.406,0.198 2.729,1.729 2.5,1.333 true 2.115,1.75 2.323,1.323 true 0.875,0.708 0.875,0.396 0.875,0.396 1.427,0.396 false 2.667,1.74 3.021,1.969 0.354,0.229 10 false IND- 0.115,0.115 0.427,0.313 0.313,0.198 10 false *a 2.031,1.76 2.385,1.99 0.354,0.229 10 false IG 1.469,0.344 1.781,0.542 0.313,0.198 10 false *b 2.406,0.354 2.865,0.552 0.458,0.198 10 false D108
*a Component without harness connected
(Front Wiper Deicer Switch)
*b Indicator light


Apply battery voltage to the connector and check the illumination conditions.

OK:
Battery Connection Specified Condition
Auxiliary Battery positive → 5(IG)
Auxiliary Battery negative → 4(IND-)
Illuminates


If the result is not as specified, replace the front wiper deicer switch.



Hide 84794 2.INSPECT FRONT WIPER DEICER SWITCH (w/o Navigation System)

a.

Inspect the front wiper deicer switch.

i.
E459262C01
1.448,0.135 1.854,0.323 0.406,0.188 1.083,1.604 1.448,1.177 true 1.594,1.76 1.594,1.177 true 2.115,1.573 1.833,1.177 true 0.135,0.146 0.448,0.344 0.313,0.198 10 false *a 2.125,1.573 2.438,1.771 0.313,0.198 10 false E 1.552,1.781 1.865,1.979 0.313,0.198 10 false D 0.958,1.594 1.271,1.792 0.313,0.198 10 false IG 1.5,0.146 1.958,0.344 0.458,0.198 10 false D108
*a Component with harness connected
(Front Wiper Deicer Switch)


Connect the D108 front wiper deicer switch connector.


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(D108)Location & Routing

Click Connector(D108)Instrument Panel>Instrument Panel Wire>Front Wiper Deicer Switch

D108-4(D) - D108-2(E) Ignition switch on (IG), Front wiper deicer switch off 11 to 14V
D108-4(D) - D108-2(E) Front wiper deicer switch on Below 1V (After 15 +/- 3 minutes 11 to 14V)
D108-5(IG) - D108-2(E) Ignition switch on (IG) 11 to 14 V


If the result is not as specified, replace the front wiper deicer switch.



b.

Check the indicator light illuminates.

i.
B454533C03
0.75,0.698 1.552,0.698 true 0.563,0.615 0.875,0.813 0.313,0.198 10 false *a
*a Indicator light


Connect the D108 front wiper deicer switch connector.

OK:
Battery Connection Specified Condition
Ignition switch on (IG), Front wiper deicer switch off → Front wiper deicer switch on Illuminates (After 15 +/- 3 minutes not Illuminates)


If the result is not as specified, replace the front wiper deicer switch.



c.

Check the illumination.

i.
E455888C02
2.365,0.385 2.771,0.583 0.406,0.198 3.01,1.323 3.01,1.656 true 2.167,1.333 2.167,1.667 true 1.375,0.313 0.875,0.313 0.875,0.313 0.875,1.021 false 2.958,1.688 3.292,1.854 0.333,0.167 10 false ILL- 0.094,0.104 0.406,0.302 0.313,0.198 10 false *a 2.094,1.677 2.708,1.875 0.615,0.198 10 false ILL+ 1.417,0.26 1.729,0.458 0.313,0.198 10 false *b 2.427,0.417 2.885,0.615 0.458,0.198 10 false D108
*a Component without harness connected
(Front Wiper Deicer Switch)
*b Illuminates


Apply battery voltage to the connector and check the illumination conditions.

OK:
Battery Connection Specified Condition
Auxiliary Battery positive → 6(ILL+)
Auxiliary Battery negative → 1(ILL-)
Illuminates


If the result is not as specified, replace the front wiper deicer switch.