84250A
1.INSPECT STEERING PAD SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Steering Pad Switch Assembly) |
*b | Up |
| *c | Down | *d | Left |
| *e | Right | *f | Ok |
| *g | Back | *h | Tel |
| *i | Voice | *j | Volume+ |
| *k | Volume- | *l | Main/ADS |
| *m | Cancel | *n | Seek+ |
| *o | Seek- | *p | MODE |
| *q | +RES | *r | -SET |
| *s | Distance Control | *t | Lane Departure Alert |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(z5)Location & Routingewd_type=routing;type=c;code=z5 Click Connector(z5)Instrument Panel>other>Spiral Cable Sub-Assembly , Steering Pad Switch Assemblyewd_type=component;type=c;code=z5;pinno=3,10,9,5,4,8,12,2 |
||
| z5-3(AU1) -z5-10(EAU) | No switch pushed | 95 to 105 kΩ |
| z5-3(AU1) -z5-10(EAU) | Seek+ switch pushed | Below 2.5 Ω |
| z5-3(AU1) -z5-10(EAU) | Seek- switch pushed | 313 to 345 Ω |
| z5-3(AU1) -z5-10(EAU) | Volume+ switch pushed | 950 to 1050 Ω |
| z5-3(AU1) -z5-10(EAU) | Volume- switch pushed | 2955 to 3265 Ω |
| z5-9(AU2) - z5-10(EAU) | No switch pushed | 95 to 105 kΩ |
| z5-9(AU2) - z5-10(EAU) | MODE switch pushed | Below 2.5 Ω |
| z5-9(AU2) - z5-10(EAU) | Tel switch pushed | 950 to 1050 Ω |
| z5-9(AU2) - z5-10(EAU) | Voice switch pushed | 2955 to 3265 Ω |
| z5-5(+DP2) - z5-10(EAU) | No switch pushed | 95 to 105 kΩ |
| z5-5(+DP2) - z5-10(EAU) | Left switch pushed | Below 2.5 Ω |
| z5-5(+DP2) - z5-10(EAU) | Up switch pushed | 313 to 345 Ω |
| z5-5(+DP2) - z5-10(EAU) | Down switch pushed | 950 to 1050 Ω |
| z5-5(+DP2) - z5-10(EAU) | Right switch pushed | 2955 to 3265 Ω |
| z5-4(+DP) - z5-10(EAU) | No switch pushed | 95 to 105 kΩ |
| z5-4(+DP) - z5-10(EAU) | Ok switch pushed | Below 2.5 Ω |
| z5-4(+DP) - z5-10(EAU) | Back switch pushed | 313 to 345 Ω |
| z5-8(DIST) - z5-12(ECC) | No switch pushed | 1 MΩ or higher |
| z5-8(DIST) - z5-12(ECC) | Distance control switch pushed | Below 2.5 Ω |
| z5-8(DIST) - z5-12(ECC) | Lane departure alert main switch pushed | 228 to 252 Ω |
| z5-2(CCS) - z5-12(ECC) | No switch pushed | 1 MΩ or higher |
| z5-2(CCS) - z5-12(ECC) | Main / ADS switch pushed | Below 2.5 Ω |
| z5-2(CCS) - z5-12(ECC) | Cancel switch pushed | 228 to 252 Ω |
| z5-2(CCS) - z5-12(ECC) | +RES switch pushed | 599 to 661 Ω |
| z5-2(CCS) - z5-12(ECC) | -SET switch pushed | 1463 to 1617 Ω |
If the result is not as specified, replace the steering pad switch assembly.
Check the illumination.
Apply battery voltage between the terminals of the switch, and check the illumination condition of the steering pad switch assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → z5-1 (IL+2) Battery negative (-) → z5-6 (ILL-) | Illuminates |
If the result is not as specified, replace the steering pad switch assembly.