Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function)
RM37H0E _58 Vehicle Interior _095303 THEFT DETERRENT / KEYLESS ENTRY _0449817 ENTRY AND START SYSTEM(for Start Function) J

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  New Key Registration Warning Message is not Displayed  


DESCRIPTION

If the new key registration warning message is not displayed after an electrical key transmitter sub-assembly has been registered, there may be communication problem between the certification ECU (smart key ECU assembly) and combination meter assembly.

CAUTION / NOTICE / HINT

NOTICE:
·

When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

·

The entry and start system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Start Function) after confirming that the communication systems are functioning properly.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.

·

After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

·

Check that there are no electrical key transmitter sub-assemblies in the vehicle.



PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Entry&Start > Trouble Codes
50001 125

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.READ VALUE USING GTS (FL DOOR COURTESY SW, FR DOOR COURTESY SW)

B

2.READ VALUE USING GTS (FL DOOR COURTESY SW, FR DOOR COURTESY SW)
a.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Door Courtesy SW Courtesy light switch RH signal ON or OFF ON: Front door RH open
OFF: Front door RH closed
for RHD
FL Door Courtesy SW Courtesy light switch LH signal ON or OFF ON: Front door LH open
OFF: Front door LH closed
for LHD
Body Electrical > Main Body > Data List
Tester Display
FR Door Courtesy SW
FL Door Courtesy SW
50003 123 197,199

Result:
Result Proceed to
On the GTS screen, ON or OFF is displayed accordingly. A
On the GTS screen, ON or OFF is not displayed accordingly. B



A

3.CHECK METER / GAUGE SYSTEM

B

3.CHECK METER / GAUGE SYSTEM
a.

With the electrical key transmitter sub-assembly in the vehicle and all of the doors closed, lock the doors using the entry lock function and check that the warning message is displayed on the multi-information display.


Result:
Result Proceed to
The warning message is displayed on the multi-information display. A
The warning message is not displayed on the multi-information display. B



A

4.ADDITIONAL KEY REGISTRATION

B

4.ADDITIONAL KEY REGISTRATION
a.

Clear all of the registered electrical key transmitter sub-assemblies except one and perform registration again.

HINT:

Refer to Service Bulletin.



Result:
Proceed to
NEXT



NEXT

5.CHECK MULTI-INFORMATION DISPLAY
5.CHECK MULTI-INFORMATION DISPLAY
a.

With all of the doors closed, lock the doors using the entry lock function.


b.

Unlock the doors using the entry unlock function, open the driver door and check that the warning message is displayed on the multi-information display.


Result:
Result Proceed to
The warning message is displayed on the multi-information display. A
The warning message is not displayed on the multi-information display. B



A

END (10 DAYS MAY HAVE ELAPSED SINCE AN ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY WAS REGISTERED)

B

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)