Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM37H0E _55 Steering _095771 STEERING GEAR / LINKAGE _0449974 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45470 1.INSPECT TIE ROD ASSEMBLY LH

Pre-procedure1

a.
C210896

Secure the tie rod assembly LH in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Install the nut to the stud bolt.


c.

Flip the ball joint back and forth 5 times.


Procedure1

a.

Using a torque wrench and the nut, turn the stud bolt continuously at a rate of 2 to 4 seconds per turn, and check the turning torque on the 5th turn.

Standard Turning Torque:
Specified Condition
0.49 to 3.43 N*m
5 to 35 kgf*cm
5 to 30 in.*lbf


HINT:

If the turning torque is not within the specified range, replace the tie rod assembly LH with a new one.



b.

Check that the ball joint dust cover is not cracked and that there is no grease on it.

HINT:

If the ball joint dust cover is cracked or there is grease on it, replace the tie rod assembly LH with a new one.



Post-procedure1

a.

None


Hide 45460 2.INSPECT TIE ROD ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 3.INSPECT TOTAL PRELOAD

Pre-procedure1

NOTICE:

Inspect the total preload in a no-load condition by removing the tie rod assembly RH, tie rod assembly LH and steering rack boots.


a.
C451380N01
3,1.333 2.833,1.333 2.833,1.333 2.281,0.969 true 3.042,1.24 3.406,1.49 0.365,0.25 10 false SST

Install SST to the pinion shaft and turn it left and right 5 times or more.

SST
09616-00011  


Procedure1

a.

Using SST and a torque wrench, turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to check the total preload of the rack and pinion power steering gear assembly.

Standard Preload:
Specified Condition
2.09 to 4.31 N*m
22 to 43 kgf*cm
19 to 38 in.*lbf


NOTICE:
·

Check the total preload around the steering rack center position.

·

Do not touch the rack bar while performing the check.



If the total preload is not within the specified range, replace the rack and pinion power steering gear assembly with a new one.


Post-procedure1

a.

None