The FC stack assembly may be damaged when the FC stack assembly or a part near the FC stack assembly is subjected to any strong impact. Therefore, perform an on-vehicle inspection (visual check).
1.CHECK FC STACK ASSEMBLY AND AREA NEAR FC STACK ASSEMBLY FOR EXTERNAL DAMAGE
Check the areas shown in the illustration for damage such as cracks, dents, chips and other deformation.
| *A | for LHD | - | - |
| *1 | Crushing and Wrinkles | *2 | Dents |
| *3 | Cracks | *4 | Cut Rubber |
| *5 | Scratches | - | - |
If any is found, the FC stack assembly may be malfunctioning.
The FC stack assembly interferes with other parts and has damage such as scratches.
Parts and areas integrated with the FC stack assembly shown in the table below interfere with other parts and have damage such as scratches.
| Parts | Parts Position | Interfering Parts |
|---|---|---|
| FC stack frame assembly | FC stack frame assembly (Crash box) | Fan with motor assembly |
| FC stack frame assembly (side) | ·
Front side member RH ·
Front side member LH |
|
| FC converter spacer (for LHD) | FC converter assembly (RH side) | ·
Front side member RH ·
Front fender apron (RH side) |
·
Front FC mounting bracket RH ·
Front FC mounting bracket LH ·
Front FC mounting insulator RH ·
Front FC mounting insulator LH |
Front | ·
Fan with motor assembly ·
Areas fastened to FC stack assembly |
| FC cooling water temperature control valve | Areas fastened to FC stack assembly | ·
Front side member LH ·
Front fender apron (LH side) |