DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ACC SW | Ignition switch ACC signal | OFF or ON | OFF: Ignition switch off
ON: Ignition switch ACC |
"ON" is also displayed for this item when the Ignition switch is ON. |
| IG SW | Ignition switch ON signal | OFF or ON | OFF: Ignition switch off
ON: Ignition switch ON |
"OFF" is also displayed for this item when the Ignition switch is ACC. |
| RR Door Courtesy SW | Rear door courtesy light switch assembly RH signal | OFF or ON | OFF: Rear door RH closed
ON: Rear door RH open |
- |
| RL Door Courtesy SW | Rear door courtesy light switch assembly LH signal | OFF or ON | OFF: Rear door LH closed
ON: Rear door LH open |
- |
| Door Key SW-Lock | Driver or front passenger door key-linked switch lock signal | OFF or ON | OFF: Driver and front passenger door key cylinder not turned to lock position
ON: Driver or front passenger door key cylinder turned to lock position |
- |
| Door Key SW-Unlock | Front passenger door key-linked switch unlock signal | OFF or ON | OFF: Front passenger door key cylinder not turned to unlock position
ON: Front passenger door key cylinder turned to unlock position |
- |
| D Door Key SW-UL | Driver door key-linked switch unlock signal | OFF or ON | OFF: Driver door key cylinder not turned to unlock position
ON: Driver door key cylinder turned to unlock position |
- |
| FR Door Lock Pos | Front door RH unlock detection switch signal | LOCK or UNLOCK | LOCK: Front door RH locked
UNLOCK: Front door RH unlocked |
- |
| FR Door Courtesy SW | Front door courtesy light switch assembly RH signal | OFF or ON | OFF: Front door RH closed
ON: Front door RH open |
- |
| FL Door Lock Pos | Front door LH unlock detection switch signal | LOCK or UNLOCK | LOCK: Front door LH locked
UNLOCK: Front door LH unlocked |
- |
| FL Door Courtesy SW | Front door courtesy light switch assembly LH signal | OFF or ON | OFF: Front door LH closed
ON: Front door LH open |
- |
| RR-Door Lock Pos SW | Rear door RH unlock detection switch signal | OFF or ON | OFF: Rear door RH closed
ON: Rear door RH open |
- |
| RL-Door Lock Pos SW | Rear door LH unlock detection switch signal | OFF or ON | OFF: Rear door LH closed
ON: Rear door LH open |
- |
| Unlock Key Twice | Key-linked 2-step unlock function | OFF or ON | Customized value displayed | - |
| Auto Lock | Speed-sensitive automatic door lock function | OFF or ON | Customized value displayed | - |
| Auto Lock/Shift | Shift-linked automatic door lock function | OFF or ON | Customized value displayed | - |
| Auto Unlock/Shift | Shift-linked automatic door unlock function | OFF or ON | Customized value displayed | - |
| All Unlock/Open-Close | Driver door-linked automatic door unlock function | OFF or ON | Customized value displayed | - |
| The Number of DTC | Number of trouble codes | 0 to 255 | Number of stored DTCs displayed | - |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Door Lock Switch Status | Multiplex network master switch assembly lock signal | OFF or ON | OFF: Lock side of multiplex network master switch assembly not pushed
ON: Lock side of multiplex network master switch assembly pushed |
- |
| Door Unlock Switch Status | Multiplex network master switch assembly unlock signal | OFF or ON | OFF: Unlock side of multiplex network master switch assembly not pushed
ON: Unlock side of multiplex network master switch assembly pushed |
- |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Double Lock Position SW | Front door LH double lock position switch signal* | OFF or ON | OFF: Double lock of front door LH UNSET
ON: Double lock of front door LH SET |
- |
*: w/ Double Locking System
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Double Lock Position SW | Front door RH double lock position switch signal* | OFF or ON | OFF: Double lock of front door RH UNSET
ON: Double lock of front door RH SET |
- |
*: w/ Double Locking System
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Double Lock Position SW | Rear door LH double lock position switch signal* | OFF or ON | OFF: Double lock of rear door LH UNSET
ON: Double lock of rear door LH SET |
- |
*: w/ Double Locking System
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Double Lock Position SW | Rear door RH double lock position switch signal* | OFF or ON | OFF: Double lock of rear door RH UNSET
ON: Double lock of rear door RH SET |
- |
*: w/ Double Locking System
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Door Lock | Door lock motor | OFF/Unlock/Lock | - |
| D-Door Unlock | Driver door lock motor | OFF/ON | - |