Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR
RM37H0E _59 Vehicle Exterior _095314 DOOR / HATCH _0452989 LUGGAGE COMPARTMENT DOOR N

DOOR / HATCH  LUGGAGE COMPARTMENT DOOR  ADJUSTMENT  


PROCEDURE

Hide 64401 1.INSPECT LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY

a.

Check that the clearance measurements of areas A to I are within the standard ranges

B600754N01
1.073,2.521 1.229,2.719 0.156,0.198 10 false A 1.219,1.969 1.375,2.167 0.156,0.198 10 false B 5.938,0.292 6.094,0.49 0.156,0.198 10 false C 5.365,0.354 5.521,0.552 0.156,0.198 10 false D 6.302,1.667 6.458,1.865 0.156,0.198 10 false E 6.813,1.552 6.969,1.75 0.156,0.198 10 false F 6.229,3.292 6.385,3.49 0.156,0.198 10 false G 6.563,3.604 6.719,3.802 0.156,0.198 10 false H 4.979,3.656 5.135,3.854 0.156,0.198 10 false I

Standard Clearance:
A -1.0 to 2.0 mm (-0.039 to 0.079 in.) B 3.0 to 6.0 mm (0.118 to 0.236 in.)
C 3.4 to 6.4 mm (0.134 to 0.252 in.) D -0.8 to 2.2 mm (-0.031 to 0.087 in.)
E -1.5 to 1.5 mm (-0.059 to 0.059 in.) F 3.7 to 6.7 mm (0.146 to 0.264 in.)
G -1.5 to 1.5 mm (-0.059 to 0.059 in.) H 4.6 to 7.6 mm (0.181 to 0.299 in.)
I 4.0 to 8.0 mm (0.157 to 0.315 in.) - -


Hide 64401 2.ADJUST LUGGAGE COMPARTMENT DOOR PANEL SUB-ASSEMBLY

a.
B600755

Loosen the hinge bolts to adjust the door horizontally and vertically.


b.

Tighten the hinge bolts after adjustment.

Torque:
13 N・m (133 kgf・cm, )


c.

Remove the rear finish plate.

Click here


d.
B600756

Loosen the striker mounting bolts.


e.

Using a brass bar and a hammer, hit the striker to adjust its position.


f.

Tighten the striker mounting bolts after adjustment.

Torque:
5.5 N・m (56 kgf・cm, )


g.

Install the rear finish plate.