84840D
1.INSPECT LUGGAGE DOOR OPENING SWITCH ASSEMBLY
| *a | Component without harness connected
(Luggage Door Opening Switch) |
Check the switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D110)Location & Routingewd_type=routing;type=c;code=D110 Click Connector(D110)Instrument Panel>Instrument Panel Wire>Luggage Door Opening Switch Assemblyewd_type=component;type=c;code=D110;pinno=5,2 |
||
| D110-5(B) - D110-2(L) | Pressed (On) | Below 1 Ω |
| D110-5(B) - D110-2(L) | Not pressed (Off) | 10 kΩ or higher |
If the result is not as specified, replace the luggage door opening switch