84840C
1.INSPECT LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY
| *a | Component without harness connected
(Luggage Door Opening Cancel Switch Assembly) |
| *b | Cancel Switch |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D87)Location & Routingewd_type=routing;type=c;code=D87 Click Connector(D87)Instrument Panel>Instrument Panel Wire>Luggage Door Opening Switch Assembly Cancelewd_type=component;type=c;code=D87;pinno=1,2 |
||
| D87-1 - D87-2 | Switch off (Not pressed) | 10 kΩ or higher |
| D87-1 - D87-2 | Switch on (Pressed) | Below 1 Ω |
If the result is not as specified, replace the luggage door opening cancel switch assembly.