84945A
1.INSPECT LUGGAGE ELECTRICAL KEY SWITCH
| *a | Component without harness connected
(Luggage Electrical Key Switch) |
Check the operation of the luggage electrical key switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(K9)Location & Routingewd_type=routing;type=c;code=K9 Click Connector(K9)Body>No. 1 Back Door Wire>Luggage Electrical Key Switchewd_type=component;type=c;code=K9;pinno=3,2 |
||
| K9-3(UL) - K9-2(E) | Fuel lid opener switch pushed (ON) | Below 1 Ω |
| K9-3(UL) - K9-2(E) | Fuel lid opener switch not pushed (OFF) | 10 kΩ or higher |
If the result is not as specified, replace the luggage electrical key switch.