Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER MOTOR ASSEMBLY
RM37H0E _59 Vehicle Exterior _095314 DOOR / HATCH _0452996 FUEL LID OPENER MOTOR ASSEMBLY G

DOOR / HATCH  FUEL LID OPENER MOTOR ASSEMBLY  INSPECTION  


PROCEDURE

Hide 77030A 1.INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY

a.
B499130C09
1.531,0.042 1.885,0.219 0.354,0.177 0.542,0.115 0.854,0.271 0.313,0.156 10 false *a 1.583,0.052 2.042,0.25 0.458,0.198 10 false G70 0.323,2.927 0.635,3.083 0.313,0.156 10 false A
*a Component without harness connected
(Fuel Lid Lock with Motor Assembly)


Check the operation of the fuel lid lock with motor assembly.

i.

Apply battery voltage to the fuel lid lock with motor assembly connector, and check that the fuel lid lock with motor assembly operates smoothly as follows.

OK:
Tester Connection Specified Condition

Click Location & Routing(G70)Location & Routing

Click Connector(G70)Body>Floor Wire / No. 3 Floor Wire>Fuel Lid Lock with Motor Assembly

G70-1 (+B) - Battery positive (+)
G70-2 (E) - Battery negative (-)
Open Operation


HINT:

If the result is not as specified, replace the fuel lid lock with motor assembly.



ii.

Measure the shaft stroke.

OK:
Area Lock Condition Specified Condition
A Fuel Lid Close 17.7 mm (0.697 in.)
Fuel Lid Open 0.0 mm (0 in.)