Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER SWITCH
RM37H0E _59 Vehicle Exterior _095314 DOOR / HATCH _0452997 FUEL LID OPENER SWITCH G

DOOR / HATCH  FUEL LID OPENER SWITCH  INSPECTION  


PROCEDURE

Hide 84841A 1.INSPECT FUEL LID OPENER SWITCH

a.
E372788C33
1.469,0.229 1.875,0.469 0.406,0.24 0.792,1.885 0.958,1.885 0.958,1.885 1.198,1.469 true 2.708,1.958 2.542,1.958 2.542,1.958 2.177,1.5 true 0.948,2.063 1.115,2.063 1.115,2.063 1.406,1.5 true 2.417,2.073 2.25,2.073 2.25,2.073 1.99,1.51 true 0.115,0.094 0.427,0.25 0.313,0.156 10 false *a 2.76,1.896 3.125,2.073 0.365,0.177 10 false ILL- 0.49,1.813 0.844,1.969 0.354,0.156 10 false ILL+ 1.542,0.292 1.917,0.479 0.375,0.188 10 false D113 2.458,1.99 2.823,2.167 0.365,0.177 10 false E 0.75,1.979 1.104,2.135 0.354,0.156 10 false IG
*a Component without harness connected
(Luggage Door Opening Switch Assembly)
*b Fuel Lid Open Switch


Check the operation of the luggage compartment door opening switch assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(D113)Location & Routing

Click Connector(D113)Instrument Panel>Instrument Panel Wire>Fuel Lid Opener Switch

D113-2(E) - D113-5(IG) Switch not pressed 10 kΩ or higher
D113-2(E) - D113-5(IG) Switch pressed Below 1 Ω




b.

Inspect the illumination.

i.

Apply auxiliary battery voltage to the luggage compartment door opening switch assembly connector, and check that the luggage compartment door opening switch assembly LED illuminates.

OK:
Tester Connection Measurement Condition Specified Condition

Click Location & Routing(D113)Location & Routing

Click Connector(D113)Instrument Panel>Instrument Panel Wire>Fuel Lid Opener Switch

D113-6(ILL+) - D113-1(ILL-) Auxiliary battery positive (+) - Terminal 1 (ILL+)
Auxiliary battery negative (-) - Terminal 5 (ILL-)
LED illuminates


If the result is not as specified, replace the luggage compartment door opening switch assembly.