Home › Vehicle Interior › DOOR LOCK › LUGGAGE COMPARTMENT DOOR LOCK › 2020.11–2021.08
RM37H0E _58 Vehicle Interior _095313 DOOR LOCK _0453006 LUGGAGE COMPARTMENT DOOR LOCK G

DOOR LOCK  LUGGAGE COMPARTMENT DOOR LOCK  INSPECTION  


PROCEDURE

Hide 64610 1.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY

a.

Check the operation of the door lock motor.

i.
B346834C05
2.635,1.75 2.719,1.75 2.719,1.75 2.719,1.5 false 3,1.75 2.833,1.75 2.833,1.75 2.833,1.5 false 0.698,0.521 1.01,0.719 0.313,0.198 10 false *a 2.073,0.531 2.385,0.729 0.313,0.198 10 false *b 2.177,1.344 2.49,1.542 0.313,0.198 10 false *c 2.521,1.688 2.833,1.885 0.313,0.198 10 false E 3.042,1.688 3.354,1.885 0.313,0.198 10 false B
*a Close (Lock)
*b Open (Unlock)
*c Component without harness connected
(Luggage Compartment Door Lock Assembly)


Move the door lock to the close (lock) position.


ii.

Apply battery voltage to the door lock motor and check the operation of the door lock motor.

OK:
Condition Result
Battery positive (+) → Terminal 1 (B)
Battery negative (-) → Terminal 2 (E)
Luggage compartment door lock motor open (unlock) operation


If the result is not as specified, replace the luggage compartment door lock assembly.



b.

Check the operation of the door courtesy switch.

i.
B346834C06
2.438,1.75 2.604,1.75 2.604,1.75 2.604,1.5 false 2.875,1.75 2.708,1.75 2.708,1.75 2.708,1.5 false 0.688,0.552 1.052,0.833 0.365,0.281 10 false *a 2.083,0.594 2.396,0.792 0.313,0.198 10 false *b 2.198,1.333 2.51,1.531 0.313,0.198 10 false *c 2.25,1.698 2.563,1.896 0.313,0.198 10 false D+ 2.927,1.698 3.24,1.896 0.313,0.198 10 false E
*a Close (Lock)
*b Open (Unlock)
*c Component without harness connected
(Luggage Compartment Door Lock Assembly)


Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
2 (E) - 3 (D+) Closed (Locked) 10 kΩ or higher
2 (E) - 3 (D+) Open (Unlocked) Below 1 Ω


If the result is not as specified, replace the luggage compartment door lock assembly.