READ DATA LIST
Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Rear Defogger Input Signal | Window defogger switch signal input condition | ON or OFF | ON: Window defogger switch is on
OFF: Window defogger switch is off |
- |
| Rear Defogger Output Signal | Window defogger output condition | ON or OFF | ON: Window defogger operates
OFF: Window defogger does not operate |
- |
| Rear Defogger Output Current | Window defogger current | Min.: 0, Max.: 255 A | Approximately 20 A (Max. 22 A) | Window defogger current when output is on |
| Status of Rear Defogger Fuse | Window defogger fuse condition | Disconnect or Connect | Disconnect: Fuse shut off
Connect: Fuse not shut off |
- |
| Rear Defogger Fuse Shut Off History | Window defogger fuse shut off history | ON or OFF | ON: Fuse has shut off history
OFF: Fuse has no shut off history |
- |
ACTIVE TEST
Using the GTS, perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
According to the display on the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Defogger Relay (Rear) | Back window assembly (window defogger wire) | OFF or ON | - |