CHECK VEHICLE APPROACHING SPEAKER CONTROLLER
Disconnect the D97 vehicle approaching speaker controller connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| D97-1 (IG) - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| D97-6 (GND) - Body ground | Ground | Always | Below 1 Ω |
Connect the D97 vehicle approaching speaker controller connector.
Measure the check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| D97-7 (SP+) -D97-8 (SP-) | Vehicle approaching speaker output | Vehicle approaching speaker operating | A waveform synchronized with the sound is output.
(See Waveform 1) |
| D97-3 (CANH) - D97-6 (GND) | CAN communication line | Ignition switch ON | Pulse generation |
| D97-4 (CANL) -D97-6 (GND) | CAN communication line | Ignition switch ON | Pulse generation |
Waveform 1
| Item | Condition |
|---|---|
| Tester Connection | D97-7 (SP+) - D97-8 (SP-) |
| Tool Setting | 1 V/DIV., 500 ms./DIV. |
| Condition | Vehicle approaching speaker operating |