CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (w/ Navigation System)
Disconnect the D81 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| D81-5 (B) - Body ground | Power source (+B) | Ignition switch off | 11 to 14 V |
| D81-6 (IG+) - Body ground | Power source (IG) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| D81-17 (GND) - Body ground | Ground | Always | Below 1 Ω |
Reconnect the D81 air conditioning amplifier assembly connector.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| D81-22 (FDEF) - Body ground | Front wiper deicer relay (DEICER) signal | Ignition switch ON, front wiper deicer switch on | Below 1 V |
| Ignition switch ON, front wiper deicer switch off | 11 to 14 V | ||
| D81-7 (LIN1) - Body ground | LIN communication | Ignition switch ON | Pulse generation |