FRONT WIPER AND WASHER CONTROL FUNCTIONS
| Control/Function | Description |
|---|---|
| Wiper speed regulation | Maintains the default speed of the front wipers even when the supply voltage or resistance changes. |
| Door open linked wiper suspend function | Stops the front wipers when the windshield wiper switch assembly is in the AUTO position, the shift lever is in P and the driver door or front passenger door is open.
|
| Wiper speed HI to LO transition control | Smoothly controls the change in speed of the wipers when the wiper speed is switched from HI to LO. |
| Service position control | When the windshield wiper switch assembly is held in the MIST position for 2 seconds or more within 45 seconds of turning the ignition switch off, stops the front wipers near the upper reverse position.
|
| Hood interference damage reduction function | ·
Operates the windshield wiper motor at a slow speed for the first cycle when the front wipers are returning from the service position to minimize damage if a wiper arm in the lock-back position contacts the hood. ·
Moves the front wipers a short distance in reverse if a wiper arm in the lock-back position contacts the engine hood and the windshield wiper motor locks up. |
| Self locking control | Holds the wipers in the park position when the ignition switch is turned to ON. |
| Washer control | The washer fluid is sprayed in the direction that the wiper is moving. Controls when the washer fluid is sprayed and stopped while windshield wiper switch assembly (washer switch) is turned on. In addition, the washer fluid spray time changes according to the vehicle speed and outside temperature. |
| Protection mode | Monitors the current, speed and temperature of the front wiper motor in order to protect the system.
|
| MIST function | Operates the wipers in LO when the windshield wiper switch assembly is held in the MIST position. |
| Auto operation | Operates the wipers as requested by the rain sensor when the windshield wiper switch assembly is in the AUTO position. |
| Vehicle speed linked wiper intermittent operation control | Controls the delay of the wipers when the windshield wiper switch assembly is in the INT position.
|
| Washer cooperation | ·
When windshield wiper switch assembly (washer switch) is on for approximately 0.3 seconds or more and the wiper operates for 1 round trip or less: If the windshield wiper switch assembly (washer switch) is on for approximately 0.3 seconds or more, the wiper operates at a speed slower than LO after 0.5 seconds elapse. Check that the wiper operation is performed twice in LO after the windshield wiper switch assembly (washer switch) is turned off. ·
When windshield wiper switch assembly (washer switch) is on for longer than 1 round trip: The wiper operation continues until the windshield wiper switch assembly (washer switch) is turned off. Check that the wiper operation is performed 3 times after the windshield wiper switch assembly (washer switch) is turned off.
|
| Drip prevention wiper function | 3 seconds after washer cooperation operation ends, operates the front wipers for 1 cycle to remove any remaining washer fluid from the windshield glass.
|
| Vehicle stopped wiper control | If the vehicle is stopped with the windshield wiper switch assembly in the LO position, the front wipers will operate for 3 cycles and then automatically change to intermittent operation with an interval of 2.5 seconds. |
*: Function to allow the wiper arms to be folded back, such as when replacing the wiper blade.
OTHER FUNCTIONS
| Control/Function | Function Description |
|---|---|
| Rear camera cleaner system (w/ Rear Camera Cleaner System) | When the washer switch (CAMERA) of the windshield wiper switch assembly is operated with the ignition switch to ON, the television camera assembly and inner mirror camera assembly are cleaned. |