Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM37H0E _59 Vehicle Exterior _095212 WIPER / WASHER _0447384 WIPER AND WASHER SYSTEM D

WIPER / WASHER  WIPER AND WASHER SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


NOTICE:
·

If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before operation history has been read out and saved, the operation history information could be lost.

·

The function "Read operation history" uses the current system time setting inside the GTS and the time counter inside the controlling ECU to calculate the timings shown in the operation history. For this reason, before reading out the operation history, first make sure that the GTS system clock is accurately set to the current time.

·

The time counter in the control ECU may deviate by up to +/- 10% due to the characteristics of the time counter.

·

The time counter in the control ECU is reset approximately 34 days before the "Current" value due to the characteristics of the time counter. Therefore, the time information stored before the 34th day may not be accurately displayed.



Operation History


HINT:

Operation history: The windshield wiper motor assembly records the wiper and washer system operation history, which can be read out using the GTS.


a.

Enter the following menus: Body Electrical / Wiper / Utility / Operation History.

Body Electrical > Wiper > Utility
Tester Display
Operation History
50005 384 52

b.

Following the instructions on the screen, save the operation history.

Wiper Operation (inactive)
Tester Display
Motor Lock Detection
Temperature Protection Detection
Overvoltage Detection
Low Voltage Detection

HINT:

Some items are not displayed depending on the type of vehicle.