FRONT WIPER FUNCTION CHECK
Door Open Linked Wiper Suspend Control
Continuously apply water to the windshield glass in front of the rain sensor.
Turn the ignition switch to ON.
Move the windshield wiper switch assembly to the AUTO position and check that the front wipers begin to operate.
When the driver side or passenger side door is opened, check that the front wipers stop in the retracted position.
Service Position Control
Turn the ignition switch off.
Within 45 seconds of turning the ignition switch off, hold the windshield wiper switch assembly in the MIST position for 2 seconds and check that the front wipers move to the highest position.
AUTO Wiper Function Check
Continuously apply water to the windshield glass in front of the rain sensor
Turn the ignition switch to ON.
Move the windshield wiper switch assembly to the AUTO position.
Check that the front wipers operate.
Check Intermittent Control Function
When the AUTO wiper function is disabled through a customize setting, the intermittent control function can be operated.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>CUSTOMIZE PARAMETERS
Turn the ignition switch to ON.
Move the windshield wiper switch assembly to the AUTO position.
Check that the intermittent operation interval can be adjusted from approximately 4 to 12.5 seconds by operating the intermittent time adjustment switch.
Vehicle Speed Linked Wiper Control
When the AUTO wiper function is disabled through a customize setting, the vehicle speed linked wiper control can be operated.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>CUSTOMIZE PARAMETERS
Turn the ignition switch to ON.
Move the windshield wiper switch assembly to the AUTO position.
Check that the front wipers operate intermittently.
WASHER FUNCTION CHECK
Washer Control Function
Controls when the washer fluid is sprayed and stopped while windshield wiper switch assembly (washer switch) is turned on. In addition, the washer fluid spray time changes according to the vehicle speed and outside temperature.
Washer Link Operation Check
If the windshield wiper switch assembly (washer switch) is on continuously for 40 seconds or more, the system determines a malfunction and the washer operation stops.
Turn the ignition switch to ON.
When windshield wiper switch assembly (washer switch) is on for approximately 0.3 seconds or more and the wiper operates for 1 round trip or less:
When the windshield wiper switch assembly (washer switch) is on for approximately 0.3 seconds or more and the wiper operates for 1 round trip or less: If the windshield wiper switch assembly (washer switch) is on for approximately 0.3 seconds or more, the wiper operates at a speed slower than LO after 0.5 seconds elapse.
Check that wiper operation is performed in LO 2 times after the windshield wiper switch assembly (washer switch) is turned off.
When the drip prevention wiper function is in operation, wiper operation is performed 3 times.
When windshield wiper switch assembly (washer switch) is on for longer than 1 round trip:
The wiper operation continues until the windshield wiper switch assembly (washer switch) is turned off. Check that the wiper operation is performed 3 times after the windshield wiper switch assembly (washer switch) is turned off.
When the drip prevention wiper function is in operation, wiper operation is performed 4 times.
Drip Prevention Wiper Function
Turn the ignition switch to ON.
With the vehicle stationary or while driving at a speed of less than approximately 7 km/h (4 mph), operate the windshield wiper switch assembly (washer switch) and check that the front wipers operate for 1 cycle approximately 3 seconds after washer cooperation operation ends.
CHECK REAR CAMERA CLEANER FUNCTION (w/ Rear Camera Cleaner System)
Turn the ignition switch to ON.
Check that washer fluid is sprayed on the rear camera when the washer switch (CAMERA) of the windshield wiper switch assembly is operated.